1.4.24 SNDCN1 17 Mainboard 1.4.25 MINI_PCI1: Mini PCI Slot Mini PCI (Peripheral Component Interconnect) is a 32-bit, 33MHz bus standard for integrated peripherals of smaller products. The mainboard provides one Mini PCI slot available to install expansion cards such as network card, SCSI card, etc. 1 2 1.4.26 CON5: CF Card Connector The mainboard provides one CF card connector (CompactFlash I/II Card). 18 Mainboard Connectors of I/O Board Type 2 --- 1.4.27 J2: 4 Pin Power Conn. Pin Assignment 1

Wear a wrist ground strap before handling components. Electrostatic discharge may damage the system's components. Jumpers Jumpers of System Board --- 1.4.1 FPSWLED: Front Panel Headers Pin Assignment LED Pin Assignment LED 1 HDD LED (+) Hard Drive LED (HD_LED) 2 Power LED (+) Power LED (ACPI_LED)3 HDD LED (-) 4 Power LED (-) 5 Reset Control (+) Reset Switch (RST_SW) 6 Power Switch (+) Power-on Switch (PWR_SW)7 Reset Control (-) 8 Power Switch (-) 9 N/A 10 N/C • HD_LED (Hard Drive LED ) If your c

18 1.4.26 CON5: CF Card Connector ........................................................................................... 18 Connectors of I/O Board Type 2 ---..........................................................................................19 1.4.27 J2: 4 Pin Power Conn. .................................................................................................. 19 1.4.28 J4/ J5: PGIO .............................................................................................

1.0 MB Dimension 170mm x 148mm Operating System Windows® XP/ Vista/ Win7 Release Date 091229 Mainboard Things You Have To Know • The images and pictures in this manual are for reference only and may vary from the product you received depending on specific hardware models, third party components and software versions. • This mainboard contains very delicate IC chips. Always use a grounded wrist strap when working with the system. • Do not touch any IC chip, lead, connector or other components. •

0: No. 1: Yes. To enable SMI generation, set F0 Index 83h[7] = 1. AMD Geode™ SC3200 Processor Data Book 32581C Core Logic Module - Bridge, GPIO, and LPC Registers - Function 0 Table 6-29. F0: PCI Header/Bridge Configuration Registers for GPIO and LPC Support (Continued) Bit Description 3 Keyboard/Mouse Access Trap SMI Status. Indicates whether or not an SMI was caused by a trapped I/O access to the keyboard or mouse. 0: No. 1: Yes. To enable SMI generation, set F0 Index 82h[3] = 1. 2 Parallel/Se

A wait is generated. 6) The cycle completes after IDE_IORDY[0:1] is reasserted. For cycles where a wait is generated and IDE_IOR[0:1] is asserted, the device places read data on IDE_DATA[15:0] for tRD before asserting IDE_IORDY[0:1]. Figure 9-24. Register Transfer to/from Device Timing Diagram AMD Geode™ SC2200 Processor Data Book Electrical Specifications 32580B Table 9-26. IDE PIO Data Transfer to/from Device Timing Parameters Symbol Parameter Mode Unit Comments0 1 2 3 4 t0 Cycle time (min) 60

7:4 INTB# (Ball C26) Target Interrupt. 0000: Disable 0100: IRQ4 1000: Reserved 1100: IRQ12 0001: IRQ1 0101: IRQ5 1001: IRQ9 1101: Reserved 0010: Reserved 0110: IRQ6 1010: IRQ10 1110: IRQ14 0011: IRQ3 0111: IRQ7 1011: IRQ11 1111: IRQ15 3:0 INTA# (Ball D26) Target Interrupt. 0000: Disable 0100: IRQ4 1000: Reserved 1100: IRQ12 0001: IRQ1 0101: IRQ5 1001: IRQ9 1101: Reserved 0010: Reserved 0110: IRQ6 1010: IRQ10 1110: IRQ14 0011: IRQ3 0111: IRQ7 1011: IRQ11 1111: IRQ15 Index 5Dh PCI Interrupt Steeri

1.1 Task B format ¦ CRT Interface: — Uses three 8-bit DACs — Support up to 135 MHz — 1280x1024 non-interlaced CRT @ 8 bpp, up to 75 Hz — 1024x768 non-interlaced CRT @ 16 bpp, up to 85 Hz ¦ TFT Interface: — Direct connection to TFT panels — 800x600 non-interlaced TFT @ 16 bpp graphics, up to 85 Hz — 1024x768 non-interlaced TFT @ 16 bpp graphics, up to 75 Hz — TFT on IDE: FPCLK max is 40 MHz — TFT on Parallel Port: FPCLK max is 80 MHz ¦ TV Interface: — Uses four 10-bit DACs — 720x480 NTSC @ 60 Hz

1.00 Contents Safety Information..........................................................................................................4 Technical Support............................................................................................................5 Conventions Used in This Guide....................................................................................5 Packing List.........................................................................................................

All rights reserved. This document is copyrighted and all rights are reserved. The information in this document is subject to change without prior notice to make improvements to the products. This document contains proprietary information and protected by copyright. No part of this document may be reproduced, copied, or translated in any form or any means without prior written permission of the manufacturer. All trademarks and/or registered trademarks contains in this document are property of th