Évaluations - 0, GPA: 0
(
)
)
|
Par ce dispositif a également d'autres instructions :
Ordinateurs - HP Integrity NonStop H-Series (16.73 mb)
Ordinateurs - HP Integrity NonStop H-Series (957.56 kb)
Ordinateurs - HP Integrity NonStop H-Series (881.66 kb)
Ordinateurs - HP Integrity NonStop H-Series (965.62 kb)
Ordinateurs - HP Integrity NonStop H-Series (676.93 kb)
Ordinateurs - HP Integrity NonStop H-Series (393.72 kb)
Ordinateurs - HP Integrity NonStop H-Series (776.57 kb)
Facilité d'utilisation
5157/5157 ACL S-Series DLT Subsystems installation Users Guide
5.6.3 Set Library Mode:
This setting enables the user to set the robotics operating mode to
Random or Sequential DLT1. Random is the operating mode that
affords complete host control of the robotics. In Random Mode,
host software, such as TSI’s Auto Cartridge Loader Media
Manager (ACLMM), is required to control the library. The
Sequential modes are locally controlled modes. Sequential DLT1
begins with any cartridge loaded into DLT1. The 5157 ALC
monitors the status of DLT1, and when the cartridge is unloaded by
the host, it loads the next cartridge in magazine numerical order.
This operation continues to cycle until all of the cartridges have
been loaded, or until an empty slot is encountered. The default is
Random.
When Sequential DLT1 is selected, an additional Sequential Mode
option is displayed that lets the user select Normal or Recirculate
options. Normal option operated as described above. In the
Recirculate mode, instead of stopping after the host has unloaded
the cartridge in the last slot, the operation continues by loading the
cartridge in Slot 1. Recirculation will continue until an empty slot is
encountered. The default for Sequential Mode is Normal. When
operating in Sequential Mode, autoclean is not an option.
5.6.4 Set Element Base:
This setting allows the user to set the base addresses of each of the
three SCSI elements of the module. In order to identify sources
and destinations in SCSI commands to the robotics, the 5157 ALC
is divided into elements, each of which is assigned a separate
designator or Element Address. The Transport Element is the
robotics mechanism itself; the Storage Elements are the ten slots in
the magazine; the Transfer Element is the drive. The 5157 ALC
reports these settings in response to the SCSI Mode Sense
command in the Element Address Assignment Page. The defaults
are Transport = 0000; Storage element base = 0001; Transfer
element base = 00F0 (DLT 1).
Installing and Configuring the 5157 ACL Tape Subsystem
5-12
... Ce manuel est également adapté pour les modèles :
Ordinateurs - HP NonStop G-Series (1.85 mb)
Ordinateurs - HP NonStop L-Series (1.85 mb)