Évaluations - , GPA: ( )

Instructions Graco Inc., Modèle PCH2401

Fabricant : Graco Inc.
Taille : 383.96 kb
Nom Fichier :

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

• IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO ONE YEAR FROM THE DATE OF ORIGINAL PURCHASE. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. Porter-Cable Corporation Jackson, TN USA 1-888-559-8550 D25803 18- ENG NOTES 19- ENG D25803 QUICK FACTS CALL 1-888-559-8550 TO FIND A LOCAL AUTHORIZED SERVICE CENTER NEAR YOU FOR REPAIRS AND SERVICE PART PURCHASES. GAS OIL WATER PRESSURE ADJUSTMENT PUMP BY-PASS MODE THERMAL RELIEF VALVE HOSE ENGINE SOAP/CHEMICALS NOZZLE MAINTENANCE SCHEDULE STORAGE OR WINTERIZING Use fresh high quality gas. Add stabilizer to fuel tank and run engine for 5 minutes before storage. Pump oil: Refer to owners manual supplied with this unit. Engine oil: Refer to engine manual supplied with this unit. Some units are equipped with a low oil sensor and adequate oil must be added or the unit will not start. Use only cold water. Don't operate unit with clogged or missing water filter/screen. Don't operate unit without adequate water supply to pump. Adequate water supply is a minimum of 20 psi and 5 gpm. The pressure setting is preset at the factory to achieve optimum cleaning. If you need to lower the pressure setting, refer to the owners manual for proper procedure. Pull gun trigger every 2 minutes while engine is running. Don't allow water to freeze in pump. Siphon RV antifreeze into pump for cold weather storage or long term storage. Never leave unit running for more than 2 minutes without pulling gun trigger; doing so may damage pump and void warranty. Pump is equipped with a thermal relief valve. If the water overheats, this valve will open and allow a gush of water to escape. Once the water is released, the valve closes allowing the pump to operate normally. Don't allow hoses to contact the HOT engine muffler during or after use. Never pull the hose to move the unit. Do not adjust or attempt maintenance without consulting engine manual or an authorized engine service center. Add stabilizer to fuel tank and run engine for 5 minutes before storage. Always turn on the water before starting the engine. Use only soaps and chemicals designed for pressure washer use. Keep nozzle unclogged. Refer to manual for cleaning procedures. Chemical/soap cannot be siphoned in high pressure setting. Only in low setting. Follow recommended maintenance schedule for engine & pump. Refer to manuals. Draw clean water through chemical inlet. Add stabilizer to fuel tank and run engine for 5 minutes before storage. Don't allow water to freeze in pump, gun, wand or hoses. Siphon RV antifreeze into pump for cold weather storage or long term storage. ALWAYS REFER TO THE MANUALS SUPPLIED WITH THIS UNIT D25803 20- ENG ...