356 692390 Wire.Stop 564A 691142 Screw 309A 795092 Motor.Starter 356A 690650 Wire.Stop (Control Cover) (Used After Code Date 356B 693010 Wire.Stop 564B 698589 Screw 07052800). 356D 496381 Wire.Stop (Control Cover) 310 692327 Bolt 357 695867 Key.Drive Pulley 578 398153 Wire Assembly(Starter Motor) 358 497316 Gasket Set.Engine 584 697734 Cover.Breather 332 690662 Nut 363 19069 Flywheel Puller Passage(Flywheel) 365 691688 Screw 585 691879 Gasket.Breather 333 802574 Armature.Magneto (Carburetor) Pas
Bolt (Starter Motor) Nut (Flywheel) 456 692299 456A 224321 459 281505S (Straight Side Cup) Plate.Pawl Friction Plate.Pawl Friction (Use with Spring/Dog Kit) Pawl.Ratchet 608A 497598 Starter.Rewind 613 691340 Screw (Muffler) 613A 691653 Screw (Muffler) 333 802574 Armature.Magneto 459A 492833 Pawl.Ratchet 613B 691114 Screw 333A 792640 Armature.Magneto (Use with (Muffler) (Screw On Spark Plug Spring/Dog Kit) 615 690340 Retainer.Governor Boot) 474 691991 Alternator Shaft ....... Note ..... 500 69108
Before installing and operating this engine read and observe all warnings, cautions and instructions on both sides of this sheet, on the engine, and in the operating & maintenance instructions. NOTE: This sheet of instructions and safety information is not meant to cover allpossible conditions and situations that may occur. Read entire Operating & Maintenance Instructions for this engine AND the instructions for the equipmentthis engine powers. Failure to follow instructions and safety informati
Briggs & Stratton does nos approve of or authorize such uses. ENGINE INSTALLATION [1\ Do not attempt to install this engine if you do not have thd appropriate tools and knowledge of small engine installatiom procedures. Use only Briggs & Stratton parts. Contact youq Authorized Service Dealer for assistance [2\ Do not modify the engine in any way without Briggs & Strattom factory approval. Any such modification is at the owner.s sold risk [3\ If the exhaust system on the old engine was supplied b
Use only Briggs & Stratton parts. Contact youq Authorized Service Dealer for assistance [2\ Do not modify the engine in any way without Briggs & Strattom factory approval. Any such modification is at the owner.s sold risk [3\ If the exhaust system on the old engine was supplied by thd equipment manufacturer, you must transfer the exhauss system and related components (original muffler and relatec pipes, brackets, clamps, and shields) to the new engine. Alk components must be in good condition [4
For electrib start, remove negative wire frol battery [11\ Do not check for spark witg spark plug removed. Use Briggr & Stratton spark tester #19368 ENGINE OPERATION WARNINF When adding fuel: Turn engine off and let engine cool at least 2 minutes beford removing gas capFill fuel tank outdoors or in well-ventilated area. Fill tank to abous 1 inch below lowest portion of neck to allow for fuel expansionKeep gasoline away from sparks, open flames, pilot lights, heat+ and other ignition sources. WAR
Before installing and operating this engine read and observe all warnings, cautions and instructions on both sides of this sheet, on the engine, and in the operating & maintenance instructions. NOTE: This sheet of instructions and safety information is not meant to cover allpossible conditions and situations that may occur. Read entire Operating & Maintenance Instructions for this engine AND the instructions for the equipmentthis engine powers. Failure to follow instructions and safety informati