|
Facilité d'utilisation
Step 2: Then, pull back on the sliding latch by placing the first finger of your free hand on the black knob protruding out the back of the saddle then placing your thumb on the fin sticking up just behind the fine tuner screw and pull the latch back with a pinching action between the thumb and first finger. Step 3: Once you have pulled back on the sliding latch, release the saddle and allow it to rotate forward. Step 3: If this part is missing stop right here and get one installed by a qualified guitar repairman.You can get this part from Depending on the guitar you purchased, the tremolo stop may or may not be engaged with the spring block. We will assume it is not engaged and show you how to engage it. Take the 3mm Allen wrench and turn the setscrew until it touches the spring block. Step 4: Now, tighten the springs with the spring claw screws so the spring block is pulled tightly against the setscrew. Step 5: Another way to pull the spring block against the tremolo stop set screw is to add another spring to the spring block and claw. Using this method is preferred because it will be easier to re-float the tremolo after setting up the bridge. 6 11 SETTING UP THE SPEEDLOADER TREMOLO BRIDGE BASE PLATE The proper setup of the SpeedLoader Tremolo Bridge looks exactly like a properly setup Original Floyd Rose Tremolo Bridge. By the way, the SpeedLoader Tremolo will retrofit an Original Floyd quite easily. The first thing you'll want to do is check to see if the top surface of the base plate of the bridge is sitting parallel to the top surface of the guitar. If the base plate appears to be tilted forward away from the top surface of the guitar or tilted back closer to the top of the guitar, then an adjustment should be made. Step 1: To level the base plate, first take the spring cover plate off the back of the guitar. Step 2: Inside the spring cavity you should find a tremolo stop. 10 Step 4: Now remove the bullet from the saddle. Step 5: If you are replacing a broken string, when you unlatch the pivoting saddle there will be no tension on the string to pull the pivoting saddle forward, so you'll have to pivot the saddle forward with your finger. You can now remove the bullet on the other end of the string from the nut by simply sliding it out the back of the nut. This is what the safety catch looks like up close. (see above) Step 6: If you try to release a saddle and pull back on the sliding latch and it won't budge, release everything and start over making certain that you don't turn the sliding latch sideways. If the sliding latch turns on its shaft, the safety catch portion of the sliding latch will not line up properly with the safety catch portion of the pivoting saddle and will cause binding. The safety catch is there to prevent the string from accidentally releasing while playing or changing strings. 7 LOADING SPEEDLOADER STRINGS Step 1: To put on the new string simply slide one of the bullets into the nut, then place the ...
Ce manuel est également adapté pour les modèles :Instruments de musique - ASM (428.44 kb)
Instruments de musique - Bich (428.44 kb)
Instruments de musique - Dagger (428.44 kb)
Instruments de musique - Eagle (428.44 kb)