Log:
Évaluations - 4, GPA: 3.8 ( )

Instructions Yamaha, Modèle YFL-514

Fabricant : Yamaha
Taille : 907.49 kb
Nom Fichier :
Langue d'enseignement: en
Aller à la télécharger



Par ce dispositif a également d'autres instructions :

Facilité d'utilisation


Checking the position Using the supplied cleaning rod accessory, insert it into the headjoint and make sure that the line on the cleaning rod is centered in the embouchure hole. Should it be off center, either right or left, follow the in structions given on the next page to properly position the tone reflector. Piccolo Alto Flute 7.5mm 26mm Tone reflector Cleaning rod Tone reflector Cleaning rod Line on the cleaning rod Flute Bass Flute 17mm 40mm When adjusting the tone reflector’s position Adjusting the tone reflector’s position requires some skill and should be done by the dealer from whom you purchased the instrument, rather than by yourself. Tone reflector Cleaning rod Cleaning rod Tone reflector 25 25 2. After tone reflector adjustment is complete, tune the instrument. When the tone reflector is too far from the •When too far right crown Piccolo/Flute Too far right Loosen the crown, push the tone reflector to the left and re-tighten the crown. Tuning is accomplished by sliding the head- joint slightly toward or away from the body. * To prevent damage to the tone reflector, wrap the end of the cleaning rod with a gauze before Headcork * Pull out on the headjoint to lower the pitch Headjoint Body carrying out the task. Crown and push it in to raise the pitch. When the tone reflector is too close to the •When too far left crown Too far left Alto Flute/Bass Flute Loosen the crown, push the tone reflector to Crown the right and re-tighten the crown. On the alto and bass flutes, tuning is accom U-joint plished by sliding the U-joint slightly toward or * If the cork has become worn or loose due to away from the body. tone reflector slippage, replace the cork with a new one (about once a year). * Do not adjust the space between the headjoint and U-joint. Doing so will degrade the pitch bal- Body ance making it difficult to tune the instrument. Headcork Headjoint 26 26e ¦ After playing the instrument . Cleaning the body 1. Insert the corner of a gauze through the hole at the end of the cleaning rod. Gauze 2. Wrap the gauze around the end of the cleaning rod, making sure no bare metal is exposed. * Exposed metal can damage the interior of the body. Gauze Cleaning rod 3. Rotate the body in the same direction that the gauze is wrapped and wipe away moisture from the instrument’s bore. Wipe away moisture from the joint sections as well. * Take extra care removing moisture from wooden instruments. Moisture left in the bore can result in cracking. Gauze Gauze Cleaning paper Cleaning paper Cleaning the exterior Taking care not to apply pressure on the keys, use a polishing cloth to wipe away fingerprints or oil from the instrument’s exterior. * When cleaning the keys, take care not to damage the pads. 27 . Pad maintenance 1. While the pads are still wet, insert a piece of cleaning paper between the pad and the tone hole and completely remove moisture from them. 2. If the pads are still sticky, use a piece of powder paper to remove the stickiness. Powder pa...

Ce manuel est également adapté pour les modèles :
Instruments de musique - YFL-774 (907.49 kb)
Instruments de musique - YFL-714H (907.49 kb)
Instruments de musique - YFL-211 (907.49 kb)
Instruments de musique - YFL-221 (907.49 kb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories