|
Instructions Yamaha, Modèle NS-C120
Aller à la télécharger
Facilité d'utilisation
YAMAHA shall not be liable for any accident caused by improper placement or installation of the speaker. PLACING THE SPEAKER Place the center speaker on top of the TV, on the floor under the TV or inside the TV rack so that it is stabilized. When placing the center speaker on top of the TV, to prevent the speaker from falling down, put the supplied velcro strips at four points on both bottom of the speaker and top of the TV. The center speaker should be set in alignment with the center of the TV screen. The positioning of the center speaker is important, because it controls the whole sound quality of a multi channel system. Set up the center speaker on the basis of your listening position by following the owner’s manual supplied with your amplifier. Notes • Do not place the center speaker on top of the TV whose area is smaller than the bottom area of the speaker. If placed, the speaker may fall and possibly cause damage or personal injury. • Though this speaker is magnetically shielded, there may be some influence on the TV picture depending on the type of TV or the placement of the speaker. In such a case, place the speaker away from the TV so that there is no influence on the TV picture. Before making connections, make sure that the amplifier is switched off. ■ Connections • Connect the screw-type input terminals at the rear of the speaker to the speaker output terminals of your amplifier with the speaker cables. • Connect the (+) terminals on both the amplifier and the speaker using one side of the cable. Connect the (-) terminals on both components using the other side of the cable. • Connect the speaker to the center terminals of your amplifier, making sure not to reverse the polarity (+, -). If this speaker is connected with reversed polarity, the sound will be unnatural and lack bass. Procedure: ® Loosen the terminal knob. @ Remove approx. 10 mm insulation from the speaker cable and insert the bare wire end properly into the terminal hole. © Tighten the knob. ® Test the security of the connections by tugging lightly on the cable at the terminal. Note Do not let the bare speaker wires touch each other as this could damage the speaker and/or the amplifier. The front cover is fastened to the enclosure at four points, and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four pegs on the inside surface of the cover with the four corresponding holes on the speaker and push gently. Note When the cover is removed, take care not to touch the speaker units with your hands or to exert excessive force with tools. SPECIFICATIONS Type..........................2-way 3-speaker bass reflex speaker system (Magnetically-shielded type) Driver............................................................10 cm cone woofer x 2 3 cm dome tweeter Nominal Impedance.............................................................6 ohms Frequency Response...............................................60 Hz - 35 kHz Nominal Input Power................................................................60 W Maximum Input Power...........................................................200 W Sensitivity................................................................88 dB/2.83 V/m Crossover Frequency..............................................................3 kHz Dimensions (W x H x D)...................................480 x 140 x 171 mm Weight....................................................................................5.2 kg Accessory.........................................................Velcro strips (4 sets) • Specifications subject to change without notice due to product improvements. • Care should be taken not to exceed the input power values noted above. YAMAHA CORPORATION O V53534Q Français ©YAMAHA NS-C120 lMODEDuUlaLOl Système D’enceintes GTR Merci pour avoir choisi le système d’enceintes YAMAHA NS-C12Q. PRECAUTIONS Lisez ces précautions attentivement avant d’utiliser vos enceintes. • Si vous notez une distorsion du son, réduisez le réglage du volume sur votre amplificateur. Ne laissez jamais votre amplificateur en position “d’écrêtage”. Sinon, les enceintes risqueraient d’être endommagées. • Lors de l’utilisation d’un amplificateur avec une puissance de sortie plus élevée que la puissance nominale d’entrée des enceintes, faites attention de ne jamais dépasser le niveau d’entrée maximum des enceintes. • N’essayez pas de nettoyer les enceintes avec des solvants chimiques car cela risquerait d’endommager la finition. Pour les nettoyer, utilisez un chiffon doux et sec. • Pour éviter que le coffret ne se déforme ou se décolore, ne placez pas les enceintes en plein soleil ou dans un endroit très humide. • Ne placez pas les enceintes dans un endroit où elles risquent d’être renversées et où des objets pourraient tomber sur elles. Un emplacement stable assurera aussi de meilleures pe...
Écrivez votre propre critique du dispositif
|
|