Évaluations - 4, GPA: 4.8
(
)
)
|
Facilité d'utilisation
Replace pressure switch 8. Replace pump / motor assembly Thermal overload 1. Lack of proper ventilation/room 1. Move compressor to a clean,well ventilated area where protector cuts out temperature too high temperature will not exceed 100°F. repeatedly 2. Decrease usage or purchase unit with higher air delivery 2. Excessive air usage, compressor too small (SCFM) Tank pressure drops when 1. Open tank drain valve 1. Close tank drain valve compressor shuts off 2. Loose connections (fittings, tubing, air 2. Check all connections with soap and water solution. If a hose, any connections, etc.) leak is detected, tighten. Or remove fitting and apply pipe Do not disassemble check valve. With air in tank, bleed tank first. 3. Check entire tank for leaks with soap and water solution 3. Tank leaks tape to threads and reassemble. Compressor runs 1. Excessive air usage, compressor too small 1. Decrease usage or purchase unit with higher air delivery continuously / air output 2. Open tank drain valve (SCFM) lower than normal 3. Loose connections (fittings, tubing, air 2. Close tank drain valve hose, any connections, etc.) 3. Check all connections with soap and water solution. If a leak is detected, tighten. Or remove fitting and apply pipe tape to threads and reassemble. 4. Replace pump / motor assembly 4. Pump wore out Excessive moisture in 1. Excessive water in tank 1. Drain tank, tilt tank to remove moisture discharge air 2. High humidity 2. Move to area of less humidity; use air line filter Safety valve pops open 1. Defective pressure switch 1. Replace pressure switch 2. Defective safety valve 2. Replace safety valve with genuine replacement part 6 7 For Replacement Parts or Technical Assistance, Call 1-800-543-6400 FP209800 13 1 2 23 24 21 20 30 29 22 19a 32 10 19 12b 9 26 18 31 14 25 11 28 7 8 16 17 18 27 6 5 4 3 12a 12b Replacement Parts List Ref. No. Description Part No. Qty. 1 Shroud assembly FP209536AV 1 2 On/off switch FP204824AV 1 3 Screw s 4 4 Manifold Cover s 1 5 Regulator s 1 6 1-1/2 in. dia. left gauge FP209528AV 1 7 1-1/2 in. dia. right gauge FP209821AV 1 8 Safety valve V-215104AV 1 9 Motor isolator n 2 10 Pressure switch FP209538AV 1 11 Check valve FP209532AV 1 12 Power cord FP209534AV 1 12a Ground screw * 1 12b Strain relief — 1 13 Housing screw u 4 14 Nut u 4 15 Drain valve D-1403 1 16 Rubber foot l 4 17 Foot bolt l 4 18 Wire (pressure switch to power switch) FP209523AV 1 19 Pump/motor assembly FP209039AV 1 19a Exhaust tube assembly FP202839AV 1 20 Wire clip FP202823AV 1 21 Screw * 1 22 Motor cover t 1 23 5 piece accessory kit FP204008AV 1 24 25 ft. recoil house MP268100AV 1 25 Plastic base t 1 26 Pressure switch tube assembly FP209535AV 1 27 Tank assembly — 1 28 Platic caps — 4 29 Washered head screw u 2 30 Motor housing Screw u 4 31 Base screw u 4 32 Pressure switch bracket — 1 Replacement parts Ki ts s Manifold assembly FP209820AV n Isolator kit (includes 4) FP209037AV l Feet kit FP209522AV u Fastener kit FP209041AV t Plastic base & motor cover FP209038AV * Standard hardware item — Not available Please provide following information: - Model number - Serial number (if any) - Part description and number as shown in parts list Address parts correspondence to: Campbell Hausfeld Attn: Customer Service 100 Production Drive Harrison, OH 45030 U.S.A. Oilless Compressors Limited Warranty 1. DURATION: From the date of purchase by the original purchaser as follows: One Year. 2. WHO GIVES THIS WARRANTY (WARRANTOR): Campbell Hausfeld / Scott Fetzer Company, 100 Production Drive, Harrison, Ohio, 45030, Telephone: (800) 543-6400. 3. WHO RECEIVES THIS WARRANTY (PURCHASER): The original purchaser (other than for purposes of resale) of the Campbell Hausfeld compressor. 4. WHAT PRODUCTS ARE COVERED BY THIS WARRANTY: This Campbell Hausfeld air compressor. 5. WHAT IS COVERED UNDER THIS WARRANTY: Substantial defects due to material and workmanship with the exceptions noted below. 6. WHAT IS NOT COVERED UNDER THIS WARRANTY: A. Implied warranties, including those of merchantability and FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED FROM THE DATE OF ORIGINAL PURCHASE AS STATED IN THE DURATION. If this compressor is used for commercial, industrial or rental purposes, the warranty will apply for ninety (90) days from the date of purchase. Some States do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. B. ANY INCIDENTAL, INDIRECT, OR CONSEQUENTIAL LOSS, DAMAGE, OR EXPENSE THAT MAY RESULT FROM ANY DEFECT, FAILURE, OR MALFUNCTION OF THE CAMPBELL HAUSFELD PRODUCT. Some States do not allow the exclusion or limitations of incidental or consequential damages, so the above limitation or exclusion may not apply to you. C. Any failure that results from an accident, purchaser’s abuse, neglect or failure to operate products in accordance with instructions provided in the owner’s manual(s) supplied with compressor. D. Pre-delivery service, e.g. assembl...
Ce manuel est également adapté pour les modèles :matériel de pompage - Attach it to this manual or file it for safekeeping. IN626701AV (2.86 mb)