Évaluations - 3, GPA: 4.3
(
)
)
|
Facilité d'utilisation
9. When you wish to turn off the CD PLAYER, set the Function /Power Switch (# 19) to the "TAPE" position. 5 Note on CD-R/RW discs - Because of non-standardized format definition/ production of CD-R/RW, playback quality and performance are not guaranteed. - Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions, such as PC performance, writing software, media ability, etc. - Do not attach a seal or label to either side of the CD-R/RW disc. It may cause a malfunction. - It is recommended to record only audio files on CD-R/RW discs for easy reading. RADIO RECEPTION 1. Set the Function /Power Switch (# 19) to the "RADIO" position. 2. Set the Band Selector (# 21) to "AM" or “FM ST” for the desired radio band. 3. Turn the Tuning Control (# 22) to tune to your desired radio station. 4. Adjust the Volume Control (# 20) to obtain the desired sound level. 5. To turn the Radio off, set the Function /Power Switch (# 19) to the “TAPE” position. TIPS FOR BEST RADIO RECEPTION 1. To insure maximum FM tuner sensitivity, the Telescopic Antenna (#1) should be fully extended and rotated to obtain the best possible reception. 2. When tuning in AM reception, to insure best AM sensitivity, try repositioning the unit until the best reception is obtained. CASSETTE RECORDER OPERATION 1. Set the Function /Power Switch (# 19) to the "TAPE" position. 2. Open the Cassette Door (# 6) by pressing the STOP/EJECT Button (# 25) and insert a pre-recorded cassette tape with the exposed tape facing upwards. Close the Cassette Door. 3. Press the Cassette Play Button (# 28) and adjust the Volume Control (# 20) to obtain the desired sound level. 4. Press the Cassette Pause Button (# 24) to suspend play. Press the same button again to resume. 5. Press the Cassette F. FWD Button (# 26) or the Cassette REW Button (# 27) to rapidly advance or rewind the tape. 6. Press the Cassette Record Button (# 29) to record either from the Radio or CD. Use the Function /Power Switch (# 19) to choose your signal source accordingly. 7. Press the STOP/EJECT Button (# 25) to stop operation. AUTOMATIC STOP To protect your cassette tapes and prevent unnecessary wear to the pinch rollrt of the cassette mechanism,this unit is equipped with an Automatic Stop System. When the tape ends during play,the Cassette Play Button (#28) will automatically release to stop the cassette from running. 6 CASSETTE TAPE OPERATING TIPS 1. High quality tapes are recommended to obtain maximum quality reproduction from recordings. 2. Tapes with playing time of 120 minutes (C-120) are not recommended because they contain thinner and longer tape that has a greater chance to malfunction and jam, which may damage the cassette mechanism. 3. To obtain good reproduction, the head should be cleaned after every 10 to 20 hours of use. It is also recommended that the cassette be kept away from excessive heat or cold. 4. If there is slack in the tape, remove the slack prior to inserting the cassette. To remove the slack, insert a pencil into the hub and rotate clockwise as shown below: Tape Supply Reel Tape Take-up Reel 5. A leader tape is provided at the beginning on each cassette. There is no recording on this area, so it is necessary to let the tape run for about five seconds to clear the head. 6. Keep the tape head clean since a dirty head can cause distorted sound or improper tape speed. Depress the Cassette Play Button (# 28) and use a small cotton swab with tape head cleaner or alcohol to clean the tape head, capstan and pinch roller as shown below: Pinch Roller Capstan Playback Head AUX IN OPERATION This CD Player provides the AUX IN JACK to enjoy your i-Pod, MP3 PLAYER MUSIC. 1. Connect the headphone jack of your external device and the AUX IN jack (18) located on the back of this CD player. (The connection cable is not included.) 2. Turn on the CD player and it will enter the AUX function mode once the AUX IN jack is plugged. 3. Start to play your i-pod, MP3 player or other audio device. 4. Slowly adjust both the volume controls on your CD player and the external device. 5. Turn off your i-pod, MP3 player etc. when finish listening. Turn the CD player off and unplug the AUX IN jack. Remark: Once the AUX IN jack is plugged, the CD player will enter the AUX mode automatically no matter the FUNCTION/POWER Switch (# 19) is in RADIO, TAPE or CD mode. Remember to disconnect the connection cable from the CD player after use in order to be able to listen to the RADIO, TAPE or CD player again. 7 CARE AND MAINTENANCE 1. Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used. 2. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places. 3. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors. 4. If drop-outs or interruptions occur in the music during CD play, or if the CD fails to play at all, its bottom surface may require cleaning. Before playing, wipe the dis...
Ce manuel est également adapté pour les modèles :Lecteurs - Hello Kitty KT2028A (1.35 mb)