Évaluations - 3, GPA: 3.3 ( )

Fabricant : Invacare Taille : 158.96 kb Nom Fichier : Langue d'enseignement:

Refer to the tub owner’s manual or to the calibration instruction sheet, part number 1154272, for the calibration procedure. ALWAYS wear rubber gloves, an apron and face shield protection during disinfecting, cleaning and rinsing procedures. In case of eye or skin contact, follow procedures on disinfectant container. CAUTION NEVER use abrasive cleaners like scouring powder or liquid cleaners containing pumice stone. The use of these types of cleaners will make the gel-coat finish of your tub scratched and dull. NEVER use cleaners containing iodine, bromine, Betadine® or methylene blue. The use of these types of cleaners will cause the tub to stain. Never use cleaners containing bleach. Use of these types of cleaners will dry out the rubber seals and gaskets and the tub will not function properly. Before starting the whirlpool pump, the water level must be completely above the whirlpool jets. Otherwise damage to the motor/pump will result. Heavy Duty Cleaning Procedure In additionto disinfecting yourtubafter every use, youwill need to performthis procedureapproximately once every 80.150 baths. 1. Clean the entire surface of the tub to remove visible tissue residue and fluid. 2. Rinse the inside surface of the tub with the shower/massage wand on the spray setting. 3. Rotate the water temperature valve to adjust the water temperature to approximately 105o F. NOTE: This will maximize the cleaning solution.s ability to clean and disinfect the system. 4. Close the drain. 5. Make sure the whirlpool jets are open. 6. Fill the tub one inch above the highest whirlpool jets. 7. Add the Invacare Heavy Duty Cleaner to the water in the tub. Refer to the chart for the proper amount. 8. Spray pre.mixed Invacare Heavy Duty Cleaner on the remaining surfaces. 9. Press the whirlpool on/off button to turn on the whirlpool pump and let the pump runfor 60 seconds. 10. Turnoffthepumpandallowtheheavydutycleaner/watersolutiontoremaininthetubfor 10 minutes. 11. During this ten.minute waiting time, take a long handled brush and thoroughly scruball interior surfaces of the tub. 12. Open the drain to allow the heavy duty/water solution to drain from the tub. 13. Use the shower/massage wand on the pulse setting and direct the spray into bothwhirlpool jets to back flush until the water discharging from the whirlpool inlet is clear. 14. Rinse the tub thoroughly with the shower wand on the spray setting. 15. Check the tub for damage and to ensure all surfaces of the tub are clean and that novisible residue remains. If residue is found, repeat STEPS 13 and 14. TUB MODEL NUMBER WATER REQUIRED TO COVER JETS (GALLONS) INVACARE HEAVY DUTY CLEANER REQUIRED (OZ)* 2800 10 40 2001 32 128 3700 30 120 3750 30 120 3800 30 120 3600 30 120 3650 48 192 3600XL 48 192 2300 25 100 3300 30 120 4300 35 140 4300HL 35 140 5300 52 208 5300HL 52 208 6300 50 200 6300ADH 50 200 4400SS 48 192 5400SS 50 200 *NOTE: If using non.Invacare heavy duty cleaner, refer to the instructions supplied with the cleaner ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :