Évaluations - 2, GPA: 4.5 ( )

Fabricant : Vulcan-Hart Taille : 378.79 kb Nom Fichier : Langue d'enseignement:

The carts are designed to accommodate covered or uncovered plates. The covered plates can be used with or without plate carriers. The uncovered plates require the use of plate carriers. Each cart is designed to hold 10 .. (27 cm) plates. If larger or smaller plates are used the capacities increase or decrease to fit. — 3 — — 4 — V SERIES INSTALLATION Before installing, verify the electrical service agrees with the specifications on the rating plate located on the lower rear of the cart. If the electrical service does not agree with the rating plate, do not proceed with installation. Contact your dealer or local Vulcan-Hart service technician immediately. Fig. 2 UNPACKING The APPLIANCE was inspected before leaving the factory. The transportation company assumes full responsibility for safe delivery upon acceptance of the shipment. Immediately after unpacking, check for possible shipping damage. If the APPLIANCE is damaged, save packing material and contact the carrier within 15 days of delivery. Check the delivery documentation for damage reporting contacts and time limits. Carefully unpack and place in a workaccessible area as near the installation position as possible. 1. Open the door and carefully remove any packaging materials and the retaining straps that hold the wire plate racks (VB) or tray slides and tray slide upright side supports (VBP/VHP). 2. Remove all scratch protective film from the cabinet. 3. On banquet carts, lift the plate racks into position on the side brackets. 4. On food holding and transport cabinets, remove cardboard element cover protector from cabinet bottom. Remove adjustable tray slides from box. Remove the tray slide supports and install them in the cabinet. a. Hook the openings in the flat flange of the support over two vertical carriage bolts on the interior of the cabinet. b. Make sure all flanges on the four supports face the door opening. Install tray slides in the cabinet. Make sure the hook on the end of the tray slide is up. LOCATION For efficient cabinet operation, choose a location that will provide easy loading and unloading without interfering with the final assembly of food orders. Fig. 3 The installation location must allow adequate clearances for servicing and proper operation. 1 POWER/HEAT 2 OFF 3 456 7 8 9 10 NSF® °F 2060 80100120 140150160170180190200210 220 0 20 40 50 60 7080 90 100 105 °C HOLDING AND TRANSPORT SYSTEM Leave adequate clearance for ease of loading and unloading. V SERIES INSTALLATION CODES AND STANDARDS The APPLIANCE must be installed in accordance with: In the United States of America: 1. State and local codes. 2. National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The National Fire Protection Association, Batterymarch Park, Quincy, MA 02269. In Canada: 1. Local codes. 2. Canadian Electrical Code, CSA C22.1 (latest edition). Copies may be obtained from The Canadian Standard Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3. ELECTRIC...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :