|
Facilité d'utilisation
PROXIMA ASA 3 FLASH UPGRADE USER GUIDE IMPRESSION A10+/A9+/A8+ 2. INTRODUCTION This User Guide has been created to provide an easy to understand description on how to flash upgrade the SW on projectors that are prepared for this in the field. It describes the methodology and the correct software and hardware to use to perform flashing without any hassle. This User Guide does only apply to the following ASK products or their equivalents: Product : IMPRESSION A10+/A9+/A8+ 3. NEEDED MATERIAL When flashing the SW a mouse Cable (301.102) and adapter (301.113B) is needed. This is optional accessories, and may be purchased separately: 301.102 / 301.113 PROXIMA ASA 4 FLASH UPGRADE USER GUIDE IMPRESSION A10+/A9+/A8+ 4. CONNECTING THE CABLES The Flash upgrade is done via the serial mouse port on the projector. This is the communication interface from the computer to the projector. All PC/notebooks are equipped with serial interface connectors, and may thus be used for this purpose. 1. Connect the computer to the projector using the regular VGA cable. IMPORTANT: Do not connect the mouse &adapter cable at this point, as it will be seen from the computer as a mouse connection. Connect the power cord. 2. Switch on the projector. 3. Switch on the computer. The projector should now show the image of your computer screen. 4. Connect the mouse cable and adapter between computer and the projector. Do not switch off the projector or the computer at this stage. The cable/adapter connects to the RS-232 serial port on the computer, and the dedicated mouse port on the projector. Make sure that your computer does not recognise the established connection as a mouse device. Moving the trackball on the remote can check this; the mouse pointer should not move. Also execute factory reset on the projector to go to default communication settings. 5. CONFIGURING THE HYPERTERMINAL SOFTWARE On the PC side, software that can perform a “terminal emulation” is needed. This is a standard component in most operating systems, and it is also available as stand alone software. Norton PCAnywhere and Norton Commander are two programs that can do this. As it is a standard component in the Windows Operating System. However we recommend that Hyperterminal is used. This can normally be found in the accessories menu. This example uses this software to explain. 1. Start Hyperterminal. 2. Enter a name for the connection you are about to make. Any name can be used, we recommend using a name that is easy to remember, as you will be able to save and recall this file later. Choose an icon for the file. 3. Under “Connect using” select the COM port that you have connected the cables to. Please note that this differs from computer to computer, but as the cables need to be connected directly to the port, a selection that lists “direct to COM x”, where x is the selected port, is correct. Normally this is COM 1 or COM 2. See below figure for reference. PROXIMA ASA 5 FLASH UPGRADE USER GUIDE IMPRESSION A10+/...
Ce manuel est également adapté pour les modèles :Projecteurs - A8+ (42.67 kb)
Projecteurs - A9+ (42.67 kb)