Évaluations - 1, GPA: 4 ( )

Fabricant : Sanyo Taille : 455.2 kb Nom Fichier : f5a9d9f1-0ef8-4462-8179-650df773301d.pdf Langue d'enseignement:

Before an attempt to replace the lens, confirm the model number (both the LCD projector and the lens) and prepare the proper lens. Lens installation is different in cabinet design (Type A and B). Before installation the lens, check cabinet design should be made. The lens cover is on the lens for protection. Be sure to remove the lens cover before installation. When installing or removing the lens, be careful not to stain, scratch or damage the lens. If you have any questions, contact the dealers. Notes on Lens Replacement Following parts are contained in the packing. LENS LIGHT-BLOCK SHEET (Spare) {Except LNS-W11 (AH-23631)} 1 piece 1 piece (Part No. 910 322 9677) Notes on Lens Replacement Parts List After the lens replacement (before attaching the top cabinet), check the following things. 1. Check the lens is properly installed. 2. Check no wiring is tangled on the gear of the lens motor or other mechanical parts. 3. Check no parts is missing, or no mounting part is lost. 1AA6P1P5412-- (IFEK-EI)Printed in Japan Lens Replacement Procedure (For A type Cabinet) (For A type Cabinet) Perform the steps 1-2 for lens replacement. First set the lens at the center position with lens shift adjustment. Remove the Lens While pressing the Lens release button on the top ofthe cabinet, turn the lens counterclockwise until it stops and pull it out slowly from the projector. Be careful not to drop the lens. 1 Fig-1-1 LENS RELEASE BUTTON Fig-1-2 Mount the Lens 1. Remove the protective caps (front and back) on the lens. 2. Insert the lens into the Lens Bracket of the projector asmatching the red mark on the lens to that on the LensBracket. 2 -2Fig- 2 Red mark 3. Slowly turn the lens clockwise until it clicks. Make sure thatthe lens is fully inserted to the projector. Lens Replacement Procedure (For B type Cabinet) (For B type Cabinet) Perform the steps 1-6 for lens replacement. First set the lens at the lowest position with lens shift adjustment. 1 Remove the Lens Cover and the Top Cabinet 1. Turn the Lens Cover counter-clockwise and pull ittoward front to remove the Lens Cover. 2. Remove the two screws (SCREW "A") and removethe Top Cabinet. 1. Pull Lens Cover toward front and remove it. 2. Remove the two screws (SCREW "A") and removethe Top Cabinet. Slide the Light-Block Sheet Base upward to remove it. 2 Remove the Light-Block Sheet Base SCREW "A" LENS COVER TOP CABINET Fig-1-1 SCREW "A" LENS COVER TOP CABINET Fig-1-2 -3Fig- 2 LIGHT-BLOCK SHEET BASE 3 Remove the Lens 3 Remove the Lens Fig-3 LENS LOCK LEVER 4 Fig-4 Insert the lens into the Lens Bracket as matching these marks. LENS BRACKET -4 5 5 Mount the Light-Block Sheet Base Mount the Light-Block Sheet Base. LIGHT-BLOCK SHEET BASE LIGHT-BLOCK SHEET Fig-5 Light-Block Sheet should belocated under the hooks. HOOKS HOOKS 6 Mount the Top Cabinet and the Lens Cover For the Cabinet Fig. 6-1 1. Mount the Top Cabinet with 2 screws. 2. Mount the Lens Cover. Position the mark "UP" of the Lens Cover on top andpush into t...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :