Évaluations - , GPA: ( )

Instructions Chamberlain, Modèle NLS1C

Fabricant : Chamberlain
Taille : 1.06 mb
Nom Fichier : 8f71b71b-4b9c-4cea-aeaf-b7e14d4c6c45.pdf

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Create New Network Before programming, clear memory on all intercoms. Press the Learn button on the new intercom until a beep is heard. Within 10 seconds put the second intercom into Learn Mode (refer to the following table). Each intercom will emit a tone when entering programming mode. It may take up to 3-1/2 minutes for a secure network to be established. Repeat for any additional intercoms. Add to an Existing Network Press the Learn button on the new intercom until a beep is heard. Within 10 seconds put any networked intercom into Learn Mode (refer to table below). Each intercom will emit a tone when entering Programming Mode. It may take up to 3-1/2 minutes for a secure network to be established. Repeat for any additional intercoms. NOTE: Do not program new intercoms to each other before adding them to the network or they will form a separate network and the memory will need to be cleared. Press and release the Talk button to verify network is complete. MONITOR HOLD OFF 1 3 2 4 VOLUME TA LK ACTIVE MONITOR HOLD OFF 1 3 2 4 VOLUME TA LK ACTIVE VOLUME MONITOR CHANNEL HOLD OFF ACTIVE TALK 13 2 4 INTERCOM LEARN MODE Press the Learn button OR until a beep is heard. HOLD ACTIVE TALK 1 3 2 4 VOLUME MONITOR CHANNEL OFF INTERCOM LEARN MODE Press the Learn button OR until a beep is heard. HOLD ACTIVE TALK 1 3 2 4 VOLUME MONITOR CHANNEL OFF Troubleshooting Intercom does not function. Check batteries in intercom. If using a DC Adapter ensure that it is plugged in. Ensure intercom is connected to a network. See Programming Intercom. Ensure that intercoms are on the same channel. See Operation & Features. Intercom is not getting expected transmission range. Keep antenna vertical. Keep intercom away from metal objects and electrical wiring. Cell phones, cordless phones, or other radio devices may also limit range. Intercom beeps every ten minutes. The battery is low in the intercom. Replace with AA Alkaline batteries or operate it with DC Adapter (not provided). A 12 Volt, 300mA DC Adapter may be used (center positive polarity on the round plug). Static and feedback is heard in intercom. The intercoms are too close to each other. A cordless phone, cell phone, or other radio devices can also cause static. The intercom does not connect to another intercom and a green light is on longer than 3-1/2 minutes. The intercom is out of range. Place the intercom closer to the other intercoms in the network, with the antenna pointing up. The other intercom in the network has no power. Replace the batteries. The intercom has not completed programming. Clear the intercom's memory and reprogram. Need to clear intercom’s memory. Press and hold Learn button, an initial beep will be heard. Continue to hold until a second beep is heard (about 6 seconds). Ensure other intercoms are not activated during this time. Once memory is clear the intercom can be programmed to a new network. Intercom is sending audio while no buttons are pressed. The sending intercom is set to Monitorin...