Évaluations - 3, GPA: 4.7
(
)
)
|
Photos et spécifications Yamaha RX-496RDS |
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
Only one side speaker outputs the sound. Incorrect setting of the BALANCE control. Adjust it to the appropriate position. Incorrect cord connections. Connect the cords properly. If the problem persists, the cords may be defective. There is a lack of bass, and no ambience. The + and – wires are connected in reverse to this unit or speakers. Connect the speaker wires in the correct phase (+ and –). Sound “hums”. Incorrect cord connections. Firmly connect the audio plugs. If the problem persists, the cords may be defective. No connection from the turntable to the GND terminal. Make the GND connection between the turntable and this unit. Sound level is low. The LOUDNESS control is functioning. Set the LOUDNESS control to the FLAT position. The volume level is low while playing a record. The record is being played on a turntable with an MC cartridge. The player should be connected to the unit through the MC head amplifier. The volume level cannot be increased, or sound is distorted. The component connected to the REC terminals of this unit is turned off. Turn the power to the component on. FMFM stereo reception is noisy. Because of the characteristics of FM stereo broadcasts, this is limited to cases where the transmitter is too far away or the antenna input is poor. Check the antenna connections. Try using a high quality directional FM antenna. Set the TUNING MODE button to the manual tuning mode. There is distortion and clear reception cannot be obtained even with a good FM antenna. There is multipath interference. Adjust antenna placement to eliminate multipath interference. A desired station cannot be tuned in with the automatic tuning method. The station is too weak. Use the manual tuning method. Use a high quality directional FM antenna. Previously preset stations can no longer be tuned in. This unit has been unplugged for a long period. Repeat the presetting procedure. AMA desired station cannot be tuned in with the automatic tuning method. Weak signal or loose antenna connections. Tighten the AM loop antenna connections and rotate it for best reception. Use the manual tuning method. There are continuous crackling and hissing noises. Noises result from ligtning, fluorescent lamps, motors, thermostats and other electrical equipment. Use an outdoor antenna and a ground wire. This will help somewhat but it is difficult to eliminate all the noises. There are buzzing and whining noises (especially in the evening). A television set is being used nearby. Relocate this unit away from the TV. Remote controltransmitter The remote control transmitter does not work. Direct sunlight or lighting (of an inverter type of fluorescent lamp etc.) is striking the remote control sensor of the main unit. Change the position of the main unit. The batteries of this remote control transmitter are too weak. Replace the batteries with new ones. OthersThe sound is degraded when listening with the headphones connected to the compact disc player or cassette deck that is connected with this unit. This unit is in the standby mode. Turn the power to this unit on. SPECIFICATIONS English AUDIO SECTION Minimum RMS Output Power per Channel (Power Amp. Section) Main L, R 8 ohms, 20 Hz to 20 kHz, 0.04% THD
Récepteur et amplificateur - RX-396 (1.51 mb)
Récepteur et amplificateur - RX-396RDS (1.51 mb)
Récepteur et amplificateur - RX-496 (1.51 mb)