Évaluations - 4, GPA: 4.3 ( )

Fabricant : Campbell Hausfeld Taille : 1.34 mb Nom Fichier : Langue d'enseignement:

SPeeD aDjUSTmenT This sander is equipped with a regulator for speed adjustment (See Replacement Parts List for Specifications). aTTaCHInG SanDInG PaD/DUaL aCTIOn SanDerS Adhesive backed discs are recommended. To apply the sandpaper, align outside edge and press self adhesive paper onto the pad. Change sandpaper as needed. Disconnect the air tool from the air supply before attaching the sanding pad. Do not operate the sander if sanding pad is not securely tightened. Always replace a worn or damaged pad. Serious injury could occur. 1. Lock the drive spindle in place before attaching the sanding pad. Rotate the spindle lock until the spindle lock engages with the drive spindle and hand- tighten the sanding pad in a clockwise direction (See Figure 1). Figure 1 Drive Spindle Spindle Lock Operating Postion Pad assembly Postion 2. Unlock the spindle before applying air pressure. nOTe: The spindle lock is for attaching and removing the sanding pad only! Do not operate the tool with the spindle locked or the sander will stall when pressure is applied to the pad. aTTaCHInG SanDInG DISCS/HIGH SPeeD SanDerS 3” or 6” resin discs with non-adhesive backs are recommended. The discs should have 7/8” diameter cutout centers for proper attachment. For best support when using discs larger than 3", use all the backup pads of equal size or smaller than the resin disc itself (See Fig. 2). To install the resin disc, follow the outlined procedures. Figure 2 4-1/2” Backup Pad 3” Backup Pad 5-1/2” Backup Pad Adapter Lock Down Insert Holding Tool Here Disconnect the air tool from the air supply before attaching the sanding disc. Do not operate the sander if sanding disc is not securely tightened or serious injury could occur. 1. Assemble the backup pads as shown in Figure 2. Make sure the recessed center of the pads face the sander. 2. Place the resin disc in front of the appropriate size pad and push the adapter lock down through the center of the pad and discs. 3. Hand tighten the adapter lockdown, then insert the holding tool into the hole shown in Figure 2. Insert a large screwdriver into the slotted hole on the adapter lock down and securely tighten. DUaL aCTIOn SanDerS Begin sanding with an abrasive grit coarse enough to remove the high spots and any excessive roughness. Follow with a second sandpaper using a grit one to two ranges finer. Continue with successively finer grits until the desired finish is obtained. Do not change from a coarse grit to a very fine grit in one step. In doing so, it is difficult to remove swirl marks that might have been made by the coarse grit abrasive. Always use the finest grit practical for the sanding operation. HIGH SPeeD SanDerS The coarse resin disc is used for removing or smoothing over welds or blending uneven metal surfaces. The most common grit is 36 (Campbell Hausfeld MP3264 discs). Worn or damaged sanding discs may break apart causing serious injury. Always replace discs as needed. aIr HOSe Refer to IN170102AV Air Hose Hookup...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :