Log:
Trier : Nom ↑   Téléchargements   Évaluation   Taille ↑  
Téléchargements : 4   Taille : 4 mb   Fabricant : Euro-Pro  
Catégorie : Machines à coudre
@name

The higher the number, the thicker the needle. A STRETCH needle isstretch needle recommended for stretch fabrics. * Do not use any needle which is bent or blunted. 5 REMOVING AND ATTACHING THE PRESSER FOOT To Remove: 1. Turn the balance wheel towards you until the needle is at its highest position 2. By lifting the lever on the back of the foot holder, the presser foot will drop off. Note: *Do not force the presser foot to remove it. To Attach: 1. Place the presser foot so that the pin on the fo

Téléchargements : 51   Taille : 1 mb   Fabricant : Euro-Pro  
Catégorie : Machines à coudre
@name

Models := EURO-PRO x 1104HV r 1104HW 1 Year Limited Warranty This warranty applies to defects resulting from imperfections in manufacture of parts entering into the manufacture and assembly of the sewing machine which this warranty accompanies, for a period of one (1) year, subject to the following conditions, exclusions and exceptions. This warranty is enforceable if said sewing machine is given reasonably good care and proper maintenance in accordance with the accompanying printed instr

Téléchargements : 4   Taille : 61 kb   Fabricant : Euro-Pro  
Catégorie : Machines à coudre
@name

In the same operation, the fabric is trimmed, serged and gathered by the constriction of the elastic tape. Preparing the sewing machine Differential feed setting: set at “N” position Stitch length: Needles: Thread tension: 4-5 use 1 or 2 needles, depending on tape width standard setting Inserting the elastic tape • Loosen screw (2) so that brake (1) at opening (4) is opened by 1.5 to 2 mm. • Place in elastic tape (3) and pass it back under the foot. • Tighten brake (1) with screw (2) ag

Téléchargements : 27   Taille : 1 mb   Fabricant : Euro-Pro  
Catégorie : Machines à coudre
@name

Rethread the machine. - The needle is threaded incorrectly. Make sure that the needle is threaded from left to right. - The needle is not properly inserted. - The batteries are installed backwards. Check the placement diagram in the battery compartment and reinstall. Caution: When removing fabric after sewing, first turn the hand wheel to raise the needle to the highest position. Then lift the presser foot and remove the fabric. This will prevent the needle from bending. 3. The sewing mac

Téléchargements : 7   Taille : 4 mb   Fabricant : Euro-Pro  
Catégorie : Machines à coudre
@name

Raise needle to its highest position and raise presser foot. Place darning plate over needle plate aligning two pins of darning plate with holes of needle plate. You may then determine the movement of the fabric yourself. See above for embroidery. BUTTONS ................................................ Model 377 Model 374 Model 373/372 Presser foot button foot - button foot Pattern selector 1-5(54321) - 4'6(lii) 1. Align two holes of button with slot of presser foot and lower foot to hold

Téléchargements : 5   Taille : 4 mb   Fabricant : Euro-Pro  
Catégorie : Machines à coudre
@name

Remove lint and thread from all parts of shuttle and wipe with a lightly oiled cloth. To reassemble: Hold shuttle by center pin and fit carefully back into shuttle race, forming perfect circle with shuttle driver.. Replace retaining ring polished side out, making sure the bottom pin fits into notch. Lock retaining ring by turning levers back into position, Refit bobbin case with bobbin. 18 FREE ARM SEWING This sewing machine can be used like a flat bed machine, but easily converts to a fre

Téléchargements : 3   Taille : 4 mb   Fabricant : Euro-Pro  
Catégorie : Machines à coudre
@name

The marks in the stitch display correspond to the patterns shown on the panel respectively, as follows: A ( ) straight stitch, middle needle position B ( ) straight stitch, left needle position C ( ) zigzag stitch with variable width D ( ) tricot stitch automatic buttonhole sewing( ) 2. Open the shuttle cover. 3. Open hinged latch of bobbin case and pull bobbin case out of machine. Release the latch and the bobbin will fall out. As long as you hold the bobbin case latch open, the bobbin cannot d

Téléchargements : 25   Taille : 7 mb   Fabricant : Euro-Pro  
Catégorie : Machines à coudre
@name

The electrical equipment (motor, foot control, light, etc.) are warranted free from defects in material and workmanship for a period of two years from the date of original purchase. Non-durable parts including, without limitation, needles, belts, bobbins, bulbs, bobbin cases, shuttles, springs, and parts which normally require replacement are specifically excluded from this warranty. This warranty is void if: (a) This product has been cleaned, serviced, modified or tampered with by anyone other

Téléchargements : 11   Taille : 4 mb   Fabricant : Euro-Pro  
Catégorie : Machines à coudre
@name

Read all instructions before using this sewing machine. This sewing machine is designed for household use. DANGER-TO REDUCE RISK OF ELECTRIC SHOCK: A sewing machine should never be left unattended when plugged in. Always unplug this sewing machine from the electrical outlet immediately after using and before cleaning. Warning -To reduce the risk of burns, fire, electric shock or injury to persons... 1. Do not allow to be used as a toy. Attention is necessary when this sewing machine is used by o

Téléchargements : 7   Taille : 4 mb   Fabricant : Euro-Pro  
Catégorie : Machines à coudre
@name

elastic fabrics and stretch lace, lingerie stretch knit. Simply stitch elastic into place, making sure it is The stitch is decorative as well as useful. evenly spaced. To do this, mark the correct length piece into quarters, then match these markings with center front and side seams. Model 377 Model 374 Model 373/372 Presser foot zigzag foot zigzag foot Pattern selector C ( ) F( ) Stitch length dial 1 to 2.5 1 to 2.5 Presser foot zigzag foot Pattern selector C( ) Stitch length dial S.S. DECORATI





catégories