Évaluations - 2, GPA: 4 ( )

Fabricant : Weed Eater Taille : 227.34 kb Nom Fichier : Langue d'enseignement:

D Always use collection bag shoulder strap when vacuuming to avoid loss of control. D Check air intake openings, elbow tube, and vacuum tubes frequently, always with the unit stopped and the power source disconnected. Keep vents and tubes free of debris which can accumulate and restrict proper air flow. Do not use with any opening blocked. Keep free of dust, lint, hair and anything that may reduce air flow. STANDARDS This product is listed by Underwriter’s Laboratories, Inc., in accordance with UL Standard 1017. If situations occur which are not covered in this manual, use care and good judgement. If you need assistance, contact your Authorized Service Dealer or call 1-800-554-6723. Failure to follow all Safety Rules and Precautions can result in serious injury. SAVE THESE INSTRUCTIONS ASSEMBLY WARNING: Unplug the unit before opening the vacuum inlet cover or attempting to insert or remove the inlet restrictor, blower tubes or vacuum tubes. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotating blades. 4 WARNING: If you receive your unit assembled, check each step to insure your unit is properly assembled and all fasteners are secure. Follow all safety information in the manual and on unit. S A standard screwdriver is required for assembly. 5 BLOWER ASSEMBLY S Insert the blower tube into the blower outlet. S Twist the blower tube clockwise until it is firmly seated in the blower outlet. S Twist the nozzle into the end of the blower tube until it is firmly seated. Make sure the nozzle points upward. Blower Tube Nozzle Blower outlet For Model 2695 only, the blower extension tube and nozzle are combined into one component. Blower Tube/Nozzle VACUUM ASSEMBLY (Some models) OPEN THE LATCH Insert a screwdriver in to the latch area on the vacuum inlet cover. Gently tilt handle of screwdriver toward the front of the blower to release the latch. Pull up on the vacuum inlet cover with your other hand. Latch Area Impeller Locking Tabs REMOVE THE INLET RESTRICTOR (Some models) An inlet restrictor is used when operating your unit as a blower. This restrictor is not used during vacuum operation and must be removed during vacuum assembly. Once the cover is opened, look for the inlet restrictor between the door and the impeller. D Remove the inlet restrictor by rotating counterclockwise (see illustration). Keep this inlet restrictor for use when using your unit as a blower later. With the restrictor removed, the upper vacuum tube will twist onto the unit. ATTACH VACUUM TUBES S On some units an arrow on the tube and the unit will help you align the tube before twisting clockwise. S Some units may include locking tabs. These tabs guide and lock the tubes into position. Once the upper tube is secure on the unit, and cannot be turned clockwise further, the lower vacuum tube may be installed onto the upper tube. Arrow Arrow Lower tube Upper tube Not all unit will have arrows ATTACH VACUUM BAG Slide the vacuum bag ...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :