• Lighting: Lighting should be bright enough to eliminate shadow and prevent eye strain. • Electrical: Electrical circuits must be dedicated or large enough to handle amperage requirements. Outlets must be located near each machine, so power or extension cords are clear of high-traffic areas. Follow local electrical codes for proper installation of new lighting, outlets, or circuits. MAKE your shop “child safe.” Ensure that your workplace is inaccessible to youngsters by closing and locking all

Bolting to Concrete Floors Lag shield anchors with lag bolts and anchor studs (Figure 5) are two popular methods for anchoring an object to a concrete floor. We suggest you research the many options and methods for mounting your machine and choose the best that fits your specific application. NOTICE Anchor studs are stronger and more permanent alter- natives to lag shield anchors; however, they will stick out of the floor, which may cause a tripping hazard if you decide to move your machine at a

REVISED AUGUST, 2008 (TR) WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT #5378TR THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. Printed in China Ak WARNING! This manual provides critical safety instructions on the proper setup, operation, maintenance and service ofthis machine/equipment. Failure to read, understand and follow the instructions given in this manual may result in serious personal injury, including amputation, electrocution or death. The

This belt is 27.5" long. The high range belt is always used on pulleys A and C without using the tensioner. This belt is 33" long. 4. Close the side cover and secure it shut with the cap screw. The lathe is now ready to use at 150 RPM. ▲WARNING Use a low RPM when machining heavy eccentric workpieces; Objects thrown from a lathe can cause serious injury or death. ▲WARNING Use a minimum of three independent clamping devices when turning eccentric workpieces on the faceplate. Failure to provid

Except for the differences noted in this insert, all other content in the Model SB1039 Owner’s Manual applies to this machine. Before operating your new lathe, you MUST read and understand this insert, the entire Model SB1039 Owner’s Manual, and the Fagor DRO Owner’s Manual to reduce the risk of injury when using this machine. Keep this insert for later reference. If you have any further questions about this manual insert or the differences between the Model SB1039F and the Model SB1039, contact

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. #8232CR Printed in China ...................................................................................................................................................................................................................................................................................................................................................

Live center installed. Figure 24. Faceplate and dead center installed. NOTICE Failure to keep dead center point well lubricated will gall the dead center and workpiece. -26- M1049 Benchtop Lathe (Mfg. Since 8/09) SHOP FOX, Using the Steady Rest The steady rest serves as a support for long shafts. The steady rest can be placed anywhere along the length of the ways. To use the steady rest, do these steps: 1. Carefully place the steady rest on the lathe bedways. 2. Loosen the finger lo