Évaluations - 1, GPA: 3
(
)
)
|
Facilité d'utilisation
The third prong (round) is the ground. Plug the product’s cord only into three-prong receptacles. Never cut off the round prong. Cutting off the ground will result in a safety hazard and void the warranty. #38347 Page 4 Assembly 1. The Handle for the Lid (#4) needs to be assembled. Remove nuts and washers from Handle. Place Handle in place on front portion of Lid and tighten screws with washers and nuts. 2. Attach the black plastic Filter to the Pump (#28). It fits over the wide opening on the side of the Pump. 3. Attach the Flexible Pipe (#27) to the Pump. It screws on the small open fitting on the top of the Pump. 4. Set the Work Shelf (#42) on the Body (#1). Filter Work Shelf Flexible Pipe Operation KNOW YOUR SOLVENTS. Do not use any highly volatile, flammable or combustible solvents. Caution: Parts being cleaned may leave flammable or combustible residue, or may contain flammable or combustible fluids that remain in the parts washer. Check for solvent fumes to verify non-flammability and non-toxicity. Use in a well ventilated area. NO SMOKING! Only use non-corrosive water based solvents. Never use highly volatile flammable solvents such as gasoline, toluene, or diesel fuel. Non water based solvents may also contain fumes that are hazardous to your health, and must not be used at any time. Keep away from any ignition sources. Immerse the pump in liquid while operating. Fluid should be replaced and parts washer cleaned on a regular basis to avoid hazardous conditions. Avoid solvent contact with skin and eyes. Chlorinated solvents, such as 1-1-1 Trichloroethane and Methylene Chloride (also known as Methyl Chloride) can chemically react with aluminum and may explode. Many tools and equipment contain aluminum. If you are in any doubt whatsoever, contact the solvent manufacturer. Note: The fusible link must be intact at all times. 1. Parts can soak in the Body, but should not be left overnight. Use the Work Shelf when using the Flexible Pipe and while cleaning small parts. Rev 06/01 #38347 Page 5 Operation (continued) 2. Do not run the Pump when small parts are in the bottom of the tank. 3. Never run the Pump without the Filter being in place. 4. Never leave the Pump running unattended. 5. Fill the Body with the water/household detergent solution. Before attempting to wash any parts, test the Parts Washer by plugging in the electrical plug and turning “ON” the Switch Box. Make sure the Pump is operating properly and the water/household detergent solution is circulating properly. To stop the Pump from operating, turn “OFF” the switch. 6. The water/household detergent solution should be replaced frequently. Always dispose of waste water properly. Contact your local disposal management agency for disposal instructions. Part Number Listing Part # Description Qty Part # Description Qty 1 Body 1 27 Flexible Pipe 1 4 Cover 1 28 Pump 1 20 Cord Shell 1 29 Feed Thru 2 22 Pan Screw 2 33 Switch Box 1 23 Clamp 1 34 Switch 1 24 Nut 3 36 Power Cord 1 25 Pan Screw 1 37 Pan Screw 1 26 Nut 1 42 Work Shelf 1 Wiring Diagram #38347 Page 6 Parts Diagram Item #38347 Page 7 ...
Ce manuel est également adapté pour les modèles :Rondelles - 38347 (197.01 kb)
Rondelles - 38347 (197.01 kb)