Évaluations - 2, GPA: 3.5
(
)
)
|
Facilité d'utilisation
To set to below 1 minute, first set to 2 minute then turn it back. it can increase the service life of the timer Water-added rinsingspinning, to be used during defoaming -spinning. 2 SPIN TIMER 4 6 8 10 Set the spinning duration depending on the category and amount of the articles. To set to below 2 minute, first set to 4 minute then turn it back. it can increase the service life of the timer HWS60-40 HWS60-50 Usage of the drain hose 4.If extra drain hose is needed , please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m. <10cm > 30mm <1.5m The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and cause incomplete drainage. 2. Do not tramp or press the drain hose. 3. If the drain hose is too long, cut it at mid point.To make smooth drainage, cut the front end of the hose slantingly. Using sequence Preparation before spinning Please make the machine stand horizontally. Confirm that the washing machine is earthed reliably . Then insert the power plug Into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. Put down the drain hose . Spin process 1 Put the laundries in properly 2 Put the gland in properly 3 Close the inner and outer cover of the spin tub 4 Do you need water-added Rinsing-spinnning Water-added rinsing-spinning has an effect that can remove the surplus liquid dirt, It works in a way as follows: Spin for about1~2 minutes Foam-removingspinning Remove most of the foam extra detergent liquid. Remove the detergentliquid remained Spin Fill water for about 1 minutes Spin for about1~2 minutes Note: If there needs no water-added rinsing-spinning , set the duration for spinning directly. The effect is best when the laundries quantity is below 80% of the rated value. 5 Take the laundry out when the spinning ends. When the spinning ends, open the top lid and the interior lid. Then take out the depression cover and laundry after the spinning drum has stopped rotation completely. Note: Refer to the Notes on Spinning carefully. If you need water-added rinsing-spinning , please check the connection between the water hose and filling inlet. Install the water inlet hose Water inlet entrance Water inlet hoseThe water hose should be connected as shown in the right figure. Notes on Spinning Use the foam-removing spinning to remove the extra detergent liquid. It can both shorten the washing time and save the water consumption. Please put in the gland properly even if the laundries .Do not leave any articles above the depression cover. Push Gland Push Proper The laundries are slanting Proper No gland quantity is small. Disposal after spinning 1 Hang up the drain hose. 2 Pull off the power plug and hang up the power cord. 3 Wipe the complete unit with soft cloth twisted dry. 4 Open the inner/outer cover of the spin tub for some time (about one hour), then cl...
Ce manuel est également adapté pour les modèles :Séchoirs - HWS60-40 (1.39 mb)
Séchoirs - HWS60-40 (1.39 mb)
Séchoirs - HWS60-50 (1.39 mb)
Séchoirs - HWS60-40 (1.39 mb)