Évaluations - 5, GPA: 4 ( )

Fabricant : AEG Taille : 574.54 kb Nom Fichier : Langue d'enseignement:

EW) from the appliance every 6 — 8 weeks and wash it by hand or in your dishwasher. The active carbon filter must be changed not later than after 1 year. The active carbon filter cannot be washed or regenerated. Good deodorization is conditional upon a suitable active carbon volume (depending on the air capacity of your fume extractor hood) and specific arrangement of the active carbon filter in your fume extractor hood. This combination ensures a positive return air supply in contrast to exhaust air operation. A decisive factor affecting deodorization is what is known as the dwell time of the aspirated air in the active carbon filter. This dwell time can only be achieved with the AEG Original Active Carbon Filter (see Special accessories) Pre- and after-running of fan Metai fat filter Instructions on active carbon filter. Cleaning the To remove and then clean my metal fat filter grille, proceed as metal fat filter follows: For reasons of safety against any unintentional switching on, remove my screw-in fuse from the holder or switch off my automatic fusing system in the fusebox. 1. Press the lock on the fat filter grille inwards and detach the fat filter at the front and rear. 2. Clean my internal housing only with warm washing-up liquid suds (never use any abrasive cleaners, brushes, or scouring agents). 3. After cleaning, re-insert both dry metal fat filters. 4. Re-insert the fuses and reconnect the appliance. Active carbon To remove and then replace 2 KL 600 carbon filters (E-No. filter 610 899 470) (for your own account from our range of special accessories), proceed as follows: For reasons of safety against any unintentional switching on, remove my screw-in fuse from the holder or switch off my automatic fusing system in the fusebox. 1. Press the lock on the fat filter grille inwards and detach the fat filter at the front and rear. 44 WPFA4 5/90 - WKA2 5/90 GB/EU f ' |EW | 2. Remove old active carbon filters (always 2) by loosening the knurled screw in the centre. 3. Clean my internal housing only with warm washing-up liquid suds (never use any abrasive cleaners, brushes, or scouring agents). 4. Insert 2 new active carbon filters KL 600. The active carbon filter is arranged before the motor housing and is mounted with the knurled screw. 5. Re-insert the fuses and reconnect the appliance. Your fume extractor hood is now ready to operate in return air mode again! Changing the fluorescent lamp (starter) You can change the fluorescent lamp or starter yourself! De-energize the appliance before changing the lamp (e.g. pull out the mains plug). 1. Slide the lighting cover to the right (860 D) or unclip and detach it (8609 D). 2. Unscrew my defective fluorescent lamp by twisting out of the sockets to the left and replace it with a new one. Important: Insert only a max. 15 W (860 D) or 16 W (8609 D) fluorescent lamp by twisting into the sockets to the right! WLW4 5/90 GB/EU WLW4 5/90 - WR1 11/8...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :