Évaluations - 2, GPA: 3 ( )

Fabricant : DCS Taille : 574.54 kb Nom Fichier : Langue d'enseignement:

Do not forget to tighten the mains lead clamp on the plug. This appliance complies with the requirements laid out in the EEC Directive 76/899. Voltage 220/240 VAC Fuse rating 13 amps See rating piate for further information. Hello Voltage and current electrical connection Important Safety instructions For the user It must be ensured that hobs are always covered so that the appliance is not damaged by excessive heat liberation. Open fireplaces on oil-, gas-, and coal-fired cookers must be avoided. During deep-frying over a cooker/hob, the appliance used for deep-frying must also be supervised during operation. The oil contained in the deep-frying appliance may spontaneously ignite through overheating. If contaminated oil is used, spontaneous ignition may occur even more readily. It should be noted that overheating may cause a fire. Flambe-cooking under the fume extractor hood is not allowed. During all work on the fume extractor hood, also during lamp change, the appliance must be de-energized (by removing the fuses or otherwise disconnecting the appliance). It is important to observe the filter change or cleaning intervals. Failure to observe these intervals may cause the risk of fire through fat deposition. 40 A = Metal fat filter grille B = Control panel C = Lighting / \ I I [rn < >- o- B Appliance description 41 First use Operation My sliding switches are arranged on the RH side (when viewed below from the front). The individual numbers and symbols have the following meanings (from left to right): ns 5* = Lighting On ofcb = Lighting Off = Lighting -m- = Blower On -m- = Blower Off = Blower setting switch 1 = Blower setting 1 2 = Blower setting 2 3 = Blower setting 3 4 = Blower setting 4 To switch on the fume extractor hood, set my blower switch to the “On” position The blower of the fume extractor hood runs. With the blower setting switch §, you can set the fume extractor hood to the power you require (depending on the amount of fume being generated by the hobs). You can separately switch my workplace lighting (hobs) on or off with the On or Off § switch. 42 DVN1 11/89 - WPF1 11/89 - WKF1 11/89 GB/EU The build-in fume extractor hood is to be switched on before cooking begins and aiiowed to run on around 15 minutes after cooking is completed. You should remove my metal fat filter (Fig. EW) from the appliance every 6 — 8 weeks and wash it by hand or in your dishwasher. The active carbon filter must be changed not later than after 1 year. The active carbon filter cannot be washed or regenerated. Good deodorization is conditional upon a suitable active carbon volume (depending on the air capacity of your fume extractor hood) and specific arrangement of the active carbon filter in your fume extractor hood. This combination ensures a positive return air supply in contrast to exhaust air operation. A decisive factor affecting deodorization is what is known as the dwell time of the aspir...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :