Évaluations - 4, GPA: 3.8 ( )

Fabricant : Panasonic Taille : 4.95 mb Nom Fichier : Langue d'enseignement:

coaxial shielded cables. Cables are available from your dealer or electronic supply house. Before you purchase any cables, be sure you know what type of output and input connectors your various com po nents require. Also determine the length of cable you’ll need. Safety Precaution Please take safety precautions to prevent the unit from falling over. WARNING The unit may tip or fall if not situated on a stable surface, if pushed or during an earthquake. Use a strong rope or chain (not included) to fasten the Projection Display firmly to a strong wall support. Before Using Reset All Memory Functions Use when moving unit to a new location, or First Time Setup needs to be redone. CH CH VOL VOL OK Reset All Memory Functions Use when moving unit to a new location, or First Time Setup needs to be redone. CH CH VOL VOL OK Requires two AA batteries (supplied). 2. Install the batteries as shown in the battery compartment. (Polarity + or - must match the markings in the compartment). Two AA size Remote Control Battery Installation CAUTION1. While pressing in on the catch, open cover in direction of arrow. 3. Press cover in direction of arrow until it snaps shut. Incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the remote control. Observe the following precautions: 1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set. 2. Do not combine a used battery with a new one. 3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”). 4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. 5. Battery replacement is necessary when the remote control acts sporadically or stops operating the Projection Display set. Getting ed Helpful Hints: (1) For frequent remote control users, replace old batteries with Alkaline batteries for longer battery life. (2) Whenever you remove the batteries, you may need to reset the remote control infrared codes. We rec om mend that you record the code on pages 58-59, prior to setting up the remote. Emergency Alert System ( EAS) Forced Tuning If a CableCARD™ is installed, the cable MSO (multiple system owner/operator) may provide an Emergency Alert System message. These messages are intended to alert the general public of important local or national emergency situations. In the event of receipt of one of these messages, the Projection Display shall immediately tune to the channel as directed by the EAS message. If the channel has been blocked using the parental control, the parental blocking has priority over the forced tune. Press the VOL- button on the unit and OK button on the Remote control at the same time for more than 3 seconds. When reset is done, power shuts off automatically. Glossary and Acronyms Before Using (continued) Glossary and Acronyms Before Using (continued) CC (Closed Captioning) EAS (Emergency Alert System) OSD (On-Screen Display) MSO (Multiple system owner/operator) Dolby Digital This is a method of coding digital signals developed by Dolby Laboratories. Apart from stereo (2-channel) audio, these signals can also be multichannel audio. A large amount of audio information can be recorded on one disc using this method. PCM (pulse code modulation) These are uncompressed digital signals, similar to those found on CDs. DTV (Digital Television) Name of the process whereby television picture and sound signals are changed to digital code for receiving and transmitting. HDTV (High Definition Television) Television with improved picture quality by increasing vertical and horizontal resolution. ATSC (Advanced Television Systems Committee) Standardization body that developed the Digital Television Terrestrial formats. HDMI (High Definition Multimedia Interface) Interface that supports every uncompressed digital format as well as all existing multi-channel audio format on a single cable. JPEG (Joint Photographic Experts Group) A system used for compressing/decoding color still pictures. MPAA (Motion Picture Association of America) Guild governing rating assignments to movies. NTSC (National Television Systems Committee) Standardization body that developed the Analog Television Terrestrial formats. Password A four (4) digit code a user must provide in order to perform a function. CableCARD™ A module that is required to receive premium digital services through the cable input. For assistance, please call : 1-888-VIEW PTV(843-9788) or, contact us via the web at: Illuminated Remote Control Location of Controls Illuminated Remote Control Location of Controls POWER SAP LIGHT MENU 1 2 3 4 5 6 7 8 0 9 RETURN CH CH VOL VOL R-TUNE REW TV/VCR SPLIT SWAP DVD/VCR CH OPEN/CLOSE PLAY PAUSE STOP REC FF PROG TV/VIDEO SLEEP EXIT TV VCR DVD DTV RCVR DBS/CBL AUX OK MUTE ASPECT FAVORITE RECALL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 20 21 22 24 25 26 27 28 29 23 19 30 1 POWER Press to turn ON and OFF. 2 TV Sets the remote to c...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :