LSW200B LSW200BG LSW200BX LSW200BXG LSW400B LSW400BG P/NO : MFL63640502 (1005-REV01) * 1 Year Warranty If material or workmanship proves defective under normal use, during the warranty period, please contact the retailer where you purchased it. This warranty is good only to the original purchaser of the product and effective only in the local area. Component Guide spacer Guide space 4 units screw 4units * LSW200B/LSW200BG LSW400B/LSW400BG * LSW200B/LSW200BG/ LSW400B/LSW400BG : M6X18mWall mount anchor Wall mount screw * LSW200BX/LSW200BXGLSW200B/LSW200BG 4 units 10 units * LSW200BX/LSW200BXG : M6X28mm LSW200BX/LSW200BXG 4 units LSW400B/LSW400BG 6 units Safety clip screw Safety clip 2 units PVC Washer Set protection cushion User manual 2 units 4 units 4 units (M4X12mm) IMPORTANT SAFETY INSTRUCTIONS Read these instructions. Due to the shallow clearance between the display and the wall, the LSW200BG/LSW200BXG and LSW400BG Wall Mounts may require the use of the included angled adapters. * Note that the included angle adapters may block other connections on the back of the TV. * Make sure the connectors on the cables connected to the display do not press against the wall. Keep these instructions. Heed all warnings. Follow all instructions. Warning This wall mount should be installed by a trained and experienced installer designated by the retailer. Having the product installed by a non-specialized installer is very dangerous and can cause damage or injury. Use a trained and experienced installer to move or replace the wall mount, if needed. Installation requires special techniques and moving or installing the product on your own can cause serious safety issues. When installing the wall mount, never hang the power or signal cable on the rear side the TV. The cord can be damaged and cause a fire, an electric shock or damage to the product. Do not install the product where the weight cannot be supported. If the strength of the location where the wall mount is installed is not strong enough, it can fall off and cause an injury. After installing the wall mount, do not hang on the product or apply severe impact to the product. The product can fall off and cause injury. ENGLISHDo not wipe the product with a wet towel and do not use any heater or humidifier below where the product is installed. If water flows into the product or if moisture and heat are applied to the product, it can cause a fire, an electric shock or problem to the product. Unplug the power cord from the power outlet before installing the product. If you install the product with the power cord plugged, it can cause an electric shock or a fire. Do not install the product near any object that may cause vibration. Do not install the product near any high voltage power cable or power source. Do not install the product with bare hands. Always wear proper work gloves. It can cause an injury. Install the product according to th...
