Évaluations - 3, GPA: 3.7
(
)
)
|
Facilité d'utilisation
This thermostat is not a 120 volt (line voltage) device. Improper installation may cause serious injury from electrical shock. This product must be installed by a qualified heating & air conditioning contractor in accordance with NEC Standards and applicable local and state codes. Mercury is toxic and may be hazardous to your health. Any replaced thermostats containing mercury must be disposed of properly. Contact local authorities for disposal information. SPECIFICATIONS Comfort Range 60°F – 80°F Comfort Control Accuracy ± 1°F (applies to settings within Comfort Range) Operating Range1 32°F – 99°F Maximum Control Accuracy ± 2°F Temperature Setting (Control) Range 50°F – 90°F heating; 60°F – 90°F cooling Switched Load Voltage 18 – 30 volts Maximum Operating Current 1.0 Amp Maximum Surge Current 3.0 Amps Low Limit Temperature2 41°F ± 9°F High Limit Temperature3 100°F ± 9°F 1 Operating Range is the temperature range in which the thermostat will accurately display temperature. 2 Low Limit Temperature is the temperature setting of an internal, temperature-controlled mechanical switch in a circuit between RH and W for Models 8344, 8348, 8363 and 8366, and between R and W2 for Models 8346 and 8365. This device is intended to prevent freezing of water pipes should battery replacement be neglected. 3 High Limit Temperature is the setting of an internal, temperature-controlled mechanical switch in the circuit between the RH and the W terminal (W and W2 terminals for Model 8348 and 8366). This device will limit the room temperature should the contacts of the heat relay remain closed. Applies to Models 8344, 8348, 8363 and 8366 only. THERMOSTAT INSTALLATION INSTRUCTIONS Step1. Choose a location to mount the thermostat • Approximately 5 feet off the floor (refer to local codes for compliance with the Americans with Disabilities Act). • On an interior wall where the temperature is most representative of the zone being controlled by the thermostat. • At least 18 inches away from an outside wall. DO NOT MOUNT THERMOSTAT… • Behind doors, in corners or other dead air spaces. • In direct sunlight, near lamps or other sources of heat. • On an outside wall or any wall exposed to an unconditioned space (i.e. garage). • In the airflow path of a supply register or near outside doors. • On a wall where concealed pipes or ductwork will affect the thermostat temperature accuracy. Step 2. Disassemble the thermostat • Flip open the cover. • Remove the face of the thermostat – no tools required. 2 Pull Here to Open Disassemble the Thermostat Step 3. Mount the thermostat on the wall There are two sets of mounting holes – one set for use when mounting to a junction box, another set for direct wall mounting. IMPORTANT! TURN OFF POWER AT THE HVAC EQUIPMENT BEFORE PROCEEDING WITH THERMOSTAT INSTALLATION! Mounting the thermostat directly to the wall (without junction box) 1. Place the thermostat wire opening over the wall opening. If replacing a thermostat, place the thermostat to cover the old thermostat silhouette. The base of the thermostat is raised to allow for wire routing behind the thermostat. 2. Level the thermostat (for appearance only) and mark the mounting hole locations. 3. Drill a 3/16” dia. hole at th...
Ce manuel est également adapté pour les modèles :Thermostats - 8363 (444.82 kb)
Thermostats - 8365 (444.82 kb)
Thermostats - 8366 (444.82 kb)
Thermostats - 8348 (444.82 kb)