Évaluations - 0, GPA: 0
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
1 Press MENU to enter the menu mode. 2 Press –=or ++ to display “LIGHT” and press (pPLAY/STOP. “OP (or All)” will flash. 3 Press –=or ++ to select “OP” or “All” and press (pPLAY/STOP. Now the setting is completed. 4 Press MENU to exit the menu mode. When the unit is not being operated (when the display shows the current time), you can illuminate the display window by pressing STOP. This enables you to check the time even in a dark place. Note The effect of the illumination may be reduced in a bright location. OAdditional Information Precautions On power • Operate the unit only on 1.5 V DC. Use one size AAA (LR03) alkaline battery. On safety • Do not operate the unit while driving, cycling or operating any motorized vehicle. On handling • Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. • Should any solid object or liquid fall into the unit, remove the batteries and have the unit checked by qualified personnel before operating it any further. On noise • Noise may be heard when the unit is placed near an AC power source, a fluorescent lamp or a mobile phone during recording or playback. • Noise may be recorded when an object, such as your finger, etc., rubs or scratches the unit during recording. On maintenance • To clean the exterior, use a soft cloth slightly moistened in water. Do not use alcohol, benzine or thinner. Keep personal credit cards using magnetic coding or spring-wound watches, etc., away from the unit to prevent possible damage from the magnet used in the speaker. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Additional 33 Troubleshooting Should any problem persist after you have made these checks, consult your nearest Sony dealer. Symptom Remedy The unit does not •The batteries have been inserted with incorrect operate. polarity. •The batteries are weak. •The buttons are locked with the HOLD switch. (If you press any button, “HOLD” will flash three times. No sound comes •The earphone is plugged in. from the speaker. •The volume is turned down completely. “FULL” is displayed •The memory is full. Erase some of the and you cannot start messages. See page 16. recording. •99 messages have been recorded in the selected file. Select another file or erase some of the messages. See page 16. Noise is heard. Recording level is low. •An object, such as your finger, etc., accidentally rubbed or scratched the unit during recording so that noise was recorded. •The unit was placed near an AC power source, a fluorescent lamp or a mobile phone during recording or playback. •Earphone plug is dirty. Clean the plug. •Microphone sensitivity is set to “SENS L”. Set it to “SENS H”. See page 30. Playback speed is too•Set the PLAY SPEED switch to “NORMAL”. fast or too slow. See page 20. “--M--D --:--” is •You have not set the clock. See page 8. ...