Évaluations - 0, GPA: 0
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
R
Q u i c k S e t u p
1
Locate parts
2
Connect the network cable
3
Plug in power cords
Locate the parts needed for installation:
On the back of the server, attach
1. Caution! Ensure that the
the network cable between the
voltage switches are set
HP SureStore
User's Guide (for
server and the network connector
correctly for your country.
Power Cords (2)
HD Server 4000
more information)
at the wall.
1
2. Plug the two power cords into
the back of the server, and
then plug the other ends of
the cords into the power
outlets.
Caution!
If you need different power
2
cords than the ones supplied,
You also need:
use power cords approved for
• A twisted-pair network cable with RJ-45 connectors (not included).
your country. See chapter 3 in
• Two power outlets.
the User's Guide.
• An IP address, subnet mask, and, optionally, the default gateway
(router). Configure them using DHCP or BOOTP, or manually at the
server control panel. See your IP administrator for this information.
4
Verify hardware installation
5
Configure IP settings
On the front of the server, switch on the power and
When the control panel prompts you (first two messages at left), do one of the following:
check the following:
v
$
• To set the IP settings using DHCP or BOOTP, press .
Press to use
DHCP/BOOTP or...
-or-
Main power light above power switch is
w
• To set the IP settings manually at the control panel, follow these steps:
on.
Power display reads HP.
1. Press $ . The third message at left appears, with the first 0 blinking.
v
Control panel display shows varying
$
2. Enter the IP address. Use v w to change the blinking number, and press to select a
Press $ to set
self-test and loading messages.
IP manually
number and move to the next space. (Use $ to move to a previous space.) Once you set
Power and activity lights for all hard
w
the last number, press to accept the new IP address.
drives blink indicating self-test, and
3. Enter the subnet mask. Press w . To change the subnet mask, press and enter a new
then power lights remain green.
one the same way you entered the IP address. When finished, press .
v
$
4. Enter the default gateway . Press w . To change the default gateway, press and enter
IP Address
a new one the same way you entered the IP address. When finished, press .
000.000.000.000
w
5. Press $ to exit setup mode, and then press to confirm.
If any of these checks fail, see chapter 11 in the User's Guide.
H P
S u r e S t o r e
N e t w o r k A t t a c h e d S t o r a g e
... Ce manuel est également adapté pour les modèles :
données dispositifs de traitement - HP J4148A Surestore CD-ROM Exp. Tower (369.26 kb)
données dispositifs de traitement - HP J4150A Surestore CD-ROM Server Plus (369.26 kb)
données dispositifs de traitement - HP J4152A Surestore CD/DVD-ROM Server (369.26 kb)
données dispositifs de traitement - HP Surestore AutoBackup PC25 (369.26 kb)