|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
a.
In the Launcher window, select the library to
be configured.
NOTE:
If you do not see the drive in
b.
In the Library window, click the Support tab.
Command View TL, determine whether the
library found the drive by looking at the
c.
In the left panel, select Restore Factory
OCP: from the Home screen, select the
Defaults. A list of components displays in the
Status tab, then select Component
right panel.
Status+Individual Drive Status. If the OCP
d.
Select Actions+Restore Defaults on All
shows the drive information correctly, check
Components.
the Ethernet cabling to the drive and the
e.
On the screen that displays, you can retain
internal network switch.
Interface Manager Network Settings, SNMP
Settings, and Trace and Event Logs. Click
16. Configure the SAN switch.
Next and then click Finish.
a.
Rezone the SAN, if necessary, to account for
To reset the Interface Manager card defaults
the new tape drive and paths.
from the Interface Manager card CLI, log in
b.
Reboot the SAN FC switch if necessary.
and enter the following command:
17. Verify that the FC port A LED on the new tape
restore system defaults imnet
drive is green when connected to a switch and
logs snmp
linked.
Skip to Step 15.
14. Run the LTO Drive Upgrade Wizard.
a.
From CVTL, on the Support tab, in the
Navigation tree, select Drive Upgrade.
b.
Select the Actions pull-down menu.
c.
Select Launch Drive Upgrade Wizard. This
launches the LTO Drive Upgrade Wizard.
d.
Follow the instructions in the LTO Drive
Upgrade Wizard.
CAUTION:
Heed the note in the
Wizard and DO NOT restore system
defaults. The wizard migrates all
necessary settings automatically.
Restoring system defaults can cause
the upgrade to fail.
e.
When the “Drive Upgrade Complete...”
status message displays, click Finish to exit
18. Close the back doors of the library.
the Wizard.
19. Ensure that the tape drive has the latest firmware
for correct operation. If necessary, upgrade the
15. To configure the new tape drive, use Command
drive firmware using the Command View TL
View TL or the Interface Manager CLI to enter the
firmware upgrade wizard or the Interface
host mapping, access control, and FC speed
Manager card CLI. See the HP Interface Manager
settings for the new tape drive. See the HP
and Command View TL User Guide for detailed
Interface Manager and Command View TL User
procedures on upgrading drive firmware.
Guide for detailed instructions.
NOTE:
After a drive replacement or firmware
upgrade, you may be required to run specific
OS commands from the HPUX host in order to
verify the drive path. See “Ensure the new drive
is CLAIMED and online” (page 12).
Page 7
... Ce manuel est également adapté pour les modèles :
données dispositifs de traitement - HP EML 103e Tape Library (543.41 kb)
données dispositifs de traitement - HP EML 245e Tape Library (543.41 kb)
données dispositifs de traitement - HP EML Base Library (543.41 kb)
données dispositifs de traitement - HP EML E-Series 103e Base Tape Library (543.41 kb)