Log:
Évaluations - 4, GPA: 3.5 ( )

Instructions Shark, Modèle GI468N 10

Fabricant : Shark
Taille : 2.53 mb
Nom Fichier :
Langue d'enseignement: en
Aller à la télécharger



Facilité d'utilisation


STEAM IRONING1 Open the water filling inlet cover. Holding the iron at a slight angle, pour the water slowly into the inlet. The soleplate design allows for ordinary tap water to be used. We recommend using the mix of 50% tap water and 50% distilled water to reduce the hardness. 2 Using the filling flask, fill the tank to a desired level without going over the “MAX” line on the water tank. 3 When you’re finished, close the inlet cover before continuing. 4 Plug the cord into a polarized 120V AC electrical outlet. 2462571 Steam burst helps to remove stubborn wrinkles and can work both horizontally and vertically. Using the Burst of Steam ButtonElectronic Make sure the water tank is at least 1/2 filled with water. 2 Select the desired fabric and tempera- ture setting after reading the garment label. 3 Place the iron on its heel, standing up on a stable and protected surface so it can heat up for approximately 2 minutes. 4 Press the steam burst button while holding the iron horizontally or vertically. Give an interval of 3 seconds of each burst. Overuse of steam burst button may cause water spitting or weak steam performance. VERTICAL STEAM5 The steam burst feature is especially useful to remove wrinkles from hanging clothes, delicate garments and other fabrics. Hold the iron in a vertical position several inches away from the articles and press the steam burst button to prime the pump. CAUTION: Do not aim iron at yourself or anyone else while using the steam burst feature. Be careful, burns or serious injury may occur. CAUTION: Never iron or steam clothes while they are being worn. If the tank runs dry, always make sure you unplug the iron from the outlet before you refill. Self-CleaningSelecting suggest that you self-clean the iron at least once every two weeks to remove scale and calcium. If you know you have very hard water we recommend that you self-clean the iron more often. 1 Set the steam control lever to any steam position. 2 Fill the water tank up to the “MAX” level. Do not overfill. 3 Stand the iron on its heel, standing up on a protected surface and plug into the electrical outlet. 4 Press the Electronic Temperature Control button to “•••” setting. Wait until the iron heats up and the Temperature Indicator lights up. 5 Hold the iron horizontally over the sink. Turn the steam control lever all the way to the right to the SELF CLEAN position. 6 Move the iron back and forth. Hot water and steam will now be ejected from the holes in the soleplate. Use caution when doing this as the water and the steam are hot enough to cause burns. The impurities and scale are washed away. 7 Continue moving the iron back and forth until all the impurities are flushed. 8 Empty the water tank as described on Page 12. Don’t touch the hot surfaces, water or steam because injury may occur. 9 Turn the Steam Control Lever to “0” position when the water tank is empty10 Place the iron back upright on its heel to cool down before storing. 12345639613421 FABRIC TYPELED ...

Ce manuel est également adapté pour les modèles :
Fers - GI468CN 12 (2.53 mb)
Fers - GI468N 12 (2.53 mb)
Fers - GI468CN 10 (2.53 mb)

Écrivez votre propre critique du dispositif



Texte du message
Votre nom :
Entrez les deux chiffres :
capcha





catégories