• If you lower the thermostat, wait until the light goes out and comes on again before ironing. ! AUTO-STOP SAFETY FEATURE 3 (depending on the model) The electronic system cuts the power off and the auto-stop warning light (L) flashes if the iron is left vertically on its heel for more than 8 minutes or for more than 30 seconds if left horizontal. To restart the iron, shake it gently until the warning light stops flashing. NB. When the auto-stop safety switch operates, the thermostat light will

Before using your iron with the steam function for the first time, we recommend that you operate it in a horizontal position for a few moments, away from your linen, i.e. press several times on the Burst of Steam button . STEAM IRONING Turbo Pro Read these instructions carefully and make sure you keep them. HELPLINE : FOR ANY PROBLEMS OR QUERIES, PLEASE TELEPHONE 0845 602 1454 (UK - calls charged at local rate) or (01) 47 51947 (Ireland) 1 YOUR STEAM IRON Instructions for use B. Spray button D.

1. Press the on/off switch and disconnect the generator from the mains. 2. Slowly unscrew the boiler cap. 3. Using a water jug, fill with maximum one 1/2 litre of water. 4. Fill the boiler, taking care that the water does not spill over. If this occurs, remove the excess water. Replace the boiler cap, screwing on tightly, reconnect your generator to the mains, and switch it on. 5.Wait until the boiler heats up (about 4 minutes). The generator and the iron are ready to use when both the iron’s th

12345678linencotton woolsilk synth. 12345678 1 - UNDERSTANDING YOUR STEAM GENERATOR English Steam control button Temperature control slide for the iron Thermostat light Boiler Iron rest plate Boiler cap Base unit power cord Iron base / steam cord “Steam ready” indicator Steam output control dial (depending on the model) On/Off switch (O/I) Steam control button Temperature control slide for the iron Thermostat light Boiler Iron rest plate Boiler cap Base unit power cord Iron base / steam cord “St

3. Place your steam generator on the edge of your sink, with the iron to one side, standing on its heel. 4. Unscrew the cord clip by turning a quarter turn to the left (18). 5. Using a coin, gently unscrew the boiler rinse plug (19). 6. Place the plastic nozzle of the rinsing pipe into the hole of the boiler and turn gently to the right until it locks. The outlet of this nozzle must be positioned over the sink (20). 7. Connect the rubber end of the rinsing pipe to a cold tap (21). 8. Turn the ta

25 Important recommendations Safety instructions • Please read these instructions carefully before first use. This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. • For your safety, this appliance conforms to the applicable standards and regulations (Low Voltage, Electomagnetic Compatibility, Environmental Directives, as applicable...

PROTECT TURBO GEBRAUCHSANWEISUNG - DAMPFGENERATOR NOTICE D’EMPLOI - GENERATEUR DE VAPEUR GEBRUIKSAANWIJZING - STOOMGENERATOR INSTRUCTIONS FOR USE - STEAM GENERATOR ISTRUZIONI PER L’USO - GENERATORE DI VAPORE 016686 - 03/05 English 1- UNDERSTANDING YOUR STEAM GENERATOR Steam control button (depending on the model) Temperature control slide for the iron Removable water tank Removable water tank filler cover Iron rest Carrying handle Boiler rinse plug and steam Iron-base steam cord Power cord stora

PRO EXPRESS TURBO INSTRUCTIONS FOR USE - STEAM GENERATOR NOTICE D’EMPLOI - GENERATEUR DE VAPEUR GEBRUIKSAANWIJZING - STOOMGENERATOR GEBRAUCHSANWEISUNG - DAMPFGENERATOR BRUGSANVISNING - DAMPGENERATOR BRUKSANVISNING - ANGSTATION KAYTTOOHJE - SILITYSKESKUS ISTRUZIONI PER L’USO - GENERATORE DI VAPORE Nнcтpyкция пo зкcплyaтaции - ПАРОГЕНЕРАТОРЕ 035613 - 45/06 GB 1- UNDERSTANDING YOUR STEAM GENERATOR Steam control button (depending on the model) Temperature control slide for the iron Removable water t

• Steam output control dial setting: -Thick fabric: increase the steam setting. -At a low temperature : set the steam output control dial to the low position. To prime the steam circuit, either before using the iron for the first time, or if you have not used the steam function for a few minutes, press the steam control button several times in a row, holding the iron away from your clothes. This will enable any cold water to be ejected from the steam circuit. 7-WHEN THE RED LIGHT “WATER TANK EMP

Right hinge standard. *** NE-242 with white float door or white raised panel door comes standard with white interior color and white exterior finish. **** Door Hardware not included. NE-242 The Model NE-242 is a surfaced mounted, non-electrical unit. Perfect for areas where you want to iron, but the wall/surface can’t be penetrated for recess mounting. You have fast access to your ironing board, without in-cabinet iron storage. This quality built model comes with an rugged 42-inch, ventilat