Évaluations - 3, GPA: 3.7 ( )

Fabricant : AEG Taille : 110.53 kb Nom Fichier : Langue d'enseignement:

WARNING: – Do not use abrasive or corrosive products. – Do not leave substances, such as lemon or tomato juice, salt water, vinegar, coffee and milk on the enameled surfaces for a long time. Stainless Steel The stainless steel parts should also be cleaned with soapy water and then dried with a soft cloth. WARNING: – Stainless steel can be stained if it remains in contact with highly calcareous water or aggressive detergents for an extended period of time. – Stainless Steel can also discolour if in contact with excessive heat. Burners and racks These parts can be removed to make cleaning easier. The burners must be washed with a sponge and soapy water or with a light detergent, wiped well and placed in their housing perfectly. After cleaning, check that the feeler of the safety valve, start-up electrode and the flame-dividing ducts are not clogged with soap or grime. The racks can be washed in the dishwasher. Gas taps WARNING: Lubrication of the gas taps must be carried out by specialized personnel, exclusively. In case of hardening or malfunctions in the gas taps, apply to the Customer Service. 5 D -Installation & Warnings D -Installation & Warnings NOTE: THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED PERSONNEL EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN FORCE. THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO PEOPLE, ANIMALS OR OBJECTS, RESULTING FROM THE FAILURE TO COMPLY WITH SUCH PROVISIONS. The appliance is designed to be embedded into heat-resistant cabinetry. Cut a hole in the top of the cabinetry, with the dimensions indicated in fig. 3, at a distance of at least 50 mm from the appliance border to the adjacent walls. WARNING: – The surrounding cabinetry must resist a minimum temperature of 75°C. – The equipment must not be installed near inflammable materials, such as curtains, cloths, etc. ( Ref to Fig. 3 on page 8) MODEL L (mm) P (mm) 600-750 560 490 900 820 490 If the are any over-head cabinets above the cooktop they must be a minimum of 762 mm (30") higher. The distance on the left and on the right side from lateral wall should be at least 110 mm (4.5”), while the distance from the back wall should be at least 25 mm (1”). It is advisable to isolate the appliance from the piece of furniture below with a separator, leaving a depression space of at least 10 mm (fig. 4). If the hob is going to be installed above an oven, precautions must be taken to guarantee installation is in accordance with current accident prevention standards. Pay particular attention to the position of the electric cable and gas pipe: they must not touch any hot parts of the oven. WARNING: If the hob is going to be installed on the top of a built in oven without forced cooling ventilation, proper air vents must be installed to guarantee an adequate ventilation, with the lower air entering with a cross section of at least 200cm2, and the higher air exiting with a cross section of at least 60 cm2. Fastening the top Every cook-top is...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :