Évaluations - , GPA: ( )

Instructions Hotpoint, Modèle 790.4282

Fabricant : Hotpoint
Taille : 2.07 mb
Nom Fichier :

Langue d'enseignement:

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Le document est chargé, s'il vous plaît patienter

Téléchargez votre Fermer

Place correctly sized cookware on the radiant surface element. Figure 3 Figure 4 2. Touch and hold the (_w_,,) key pad until a beep sounds. The power indicator light will turn ON. Note: If no key pad is touched within 20 seconds the request to Power ON the cooktop will clear. • Outer 3. Touch and hold the (_o,/offl/pad for the dual element position until a beep is heard. The Inner display will show " --" Note: If no further pads are touched within 10 seconds the request to power the element ON will clear. 4. If the pan sensing feature is off, select the INNER (Figure 3) or OUTER (both elements) Figure 5 (Figure 4) to heat by pressing the E_..... t had _ Size _ once or twice (Figures 4 & 5 show indicator lights with OUTER and INNER elements selected). Note: If no element size is chosen when the dual element is turned ON, the control will default to the inner coil only. If the pan sensing feature is on, the element size key is disabled and the appropriate element size is automatically selected according to the pan size. 5. Touch HI pad once to turn ON the power level to HI (See Figure 5). Touch Lo V9 pad once for Lo. 6. Each touch of the HI pad will decrease or increase the power level from 9.5 through 3.0 by .5 increments. Simmer power levels between 3.0 and 1.2 will decrease or increase by .2 increments. Lo is the lowest power level available. Note: The power level may be adjusted at any time while the element is ON. 7. Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking. Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area. 8. When cooking has been completed touch the (on/off'i/pad once to turn the element OFF and if no other surface element J is used touch the _WEj_ key pad to turn off the cooktop. Note: The HE (hot element) message will remain ON if the cooktop is still hot and will remain ON until the heating surface area has cooled sufficiently. Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently. Do not place aluminum foil or plastic items such as saff and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements. 11 Setting Surface Controls (cont'd) Operating the Bridge Surface Element The cooktop is equipped with a"BRI DGE" surface eJement locatedat the leftcooktop position (See Figures I & 2). Indicatorlights on the cooktop are used to indicatewhat portions of the Bridge eJementwill heat. The Bridge element begins with the leftFRONT position only (Figures 3 & 4) and F...