Évaluations - 2, GPA: 4.5
(
)
)
|
Facilité d'utilisation
Country gray is available for the DVA4136 and DVB4136 only. Read these instructions before attempting to install A the panels. CAUTION: Before starting installation of the CR Kit allow unit to cool completely if Ait has been in operation. Ceramic refractory panels are fragile until held in place and supported. Handle with care to avoid damaging or breaking. Kit contents: • Left Side Panel (1) • Right Side Panel (1) • Rear Panel (1) • Installation Instruction Sheet (not shown) (1) Installation Instructions Turn OFF gas and electrical supply to unit before starting the CR kit installation. 1. Check all contents for damage or missing parts. 2. When the unit is cool, remove top louvre. (Refer to Homeowner’s Manual) 3. Open bottom louvre. 4. Remove the glass frame window. (Refer to Homeowner’s Manual) 5. Make sure logs are not hot and remove them. Logs are fragile and easy to break. Handle with care. 6. Remove all the lava rock from the firebox floor. Save for later. 7. Remove the deflector inside the firebox just behind the glass. Save the screws. 8. Place the rear panel over the ledge of the rear log support bracket. You may need to loosen the screws securing the bracket. Re-tighten the screws after placing the ceramic panel in place. 9. Place one of the side panels into place. It will hold the rear panel secure. 10. Place the other side panel into place. 11. Reinstall the deflector using the saved screws. 12. Re-install the lava rock. (Refer to Homeowner’s Manual) 13. Reinstall the logs. (Refer to Homeowner’s Manual) 14. Reinstall the glass frame window and close the clamps. 15. Installation is complete. 16. Attach the top louvre (Refer to Homeowner’s Manual), turn ON the gas supply and electrical supply, light the unit and close the bottom louvre. _CFM Corporation_ 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 800-668-5323 • 10009406 6/07 Rev. 2...
Ce manuel est également adapté pour les modèles :Ventilateurs - DVB4136 (152.21 kb)