Évaluations - 4, GPA: 4 ( )

Fabricant : Best Taille : 613.74 kb Nom Fichier : Langue d'enseignement:

The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65. C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100.C. After approximately three years of use, the carbon filter should be replaced with a new, as the odour reduction capacity will be reduced. • Fitting 1. Pull out the vapour catcher (A). 2. Remove first the rear then the front grease filters. 3. Insert the charcoal filter into the lugs of the frame above using the 2 red clips to retain it, press the red clips inwards, and insert the charcoal filter in the frame. Fig. 3. • Removing: 1. Press both red lugs upwards (towards the inside of the housing) and remove the charcoal filter downwards. 2. Clean the internal housing only with warm washing-up liquid’ suds (never use any abrasive cleaners, brushes, or scouring agents). • Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. • The charcoal filter can be ordered from your local Service Force Centre. Fig. 3 Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb(s) • Disconnect the unit from the mains power supply. • Unlock the lighting cover (D) by twisting the bolts to the left and fold down the bulb cover. Fig. 4. Replace the old light bulb(s) with a new light bulb of the same kind. • Close the bulb cover and relock it by twisting the bolts to the right. • If the light does not come on, make sure the bulb has been inserted correctly before contacting your local Service Force Centre. Fig. 4 D Special accessories Charcoal filter KF 8 E-Nr. 942 118 648 Front panel M BF6060-m Front panel AL BF6060-al Finishing strip* Clips for finishing strip (3x)* 942 120 646 942 120 647 ET-NR.: 502 426 420 02 ET-NR.: 502 302 940 06 * ET-NR. contact our Service Force Centre What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected The cooker hood is not working effectively.. Check that: The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air. If set up for recirculation, check that the charcoal filter is still effective. If set up for extraction, check that the ducting and outlets are not blocked. The cooke...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :