Évaluations - 2, GPA: 4.5 ( )

Fabricant : Dimplex Taille : 200.08 kb Nom Fichier : Langue d'enseignement:

1. Select the position for the heater ensuring there is clearance from any furniture and fittings of at least 150mm above the heater, 50mm below and 25mm each side. Curtains must not be closer than 150mm from the top of theheater. 2. Position the drilling template provided on the wall ensuring it is level. Mark the position of the relevant holes on the wall at the edge of template. Before drilling check that the distance between the hole centres is correct, 340mm for 400W Models and 540mm for 800W models (see Fig. 2). 130mm 340mm - 400W 540mm - 800W 95mm 150mm 50mm 420mm25mm 25mm 130mm Drilling Holes Bracket Fig. 2 3. Drill the wall at the three marked positions and fit the wall plugs. Ensure template has been removed. 4. Fix two No. 8 screws to the top two holes leaving 3mm of the screw exposed. Hang the heater on the screws. 5. Fit the bottom bracket, found in the fixing kit, in the slot at the base of the heater and screw the bracket to the wall. Test that the heater is now securely fixed to the wall. Operation IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE PLACED ON THIS HEATER. Before using the heater ensure that all warnings and instructions have been read carefully. OPERATION - SINGLE RATED MODELS Models DXLWP400, DXLWP400TI, DXLWP800, and DXLWP800TI N Turn the heater on using the switch on the right side of the heater -the switch will be illuminated. OPERATION - DUAL RATED MODEL - Model ARLWP800TI The two switches on the side of the heater control the heat output. Both switches illuminated indicates maximum output. Top switch only illuminated indicates 500W output on 800W model. Bottom switch only illuminated indicates 300W output on 800W model. Note: on models fitted with a timer, at least one switch must be illuminated for the heater to operate. MODELS WITH TIMER -(see Fig. 3) DXLWP400TI and DXLWP800TI N - 1 Switch, The switch on the side of the heater turns the heater on. Note: This switch must be in the “on” position before the heater will operate. ARLWP800TI - 2 Switches The two switches on the side of the heater control the amount of heat available as described above, (Operation - Dual Rated Model). NOTE: At least one switch must be in the ‘On’ position before the heater will operate. Models with Timer DXLWP400TI, DXLWP800TI N & ARLWP800TI Set the I - .......... - O slide switch on the timer (Fig. 3) to : Position O - Heating Off Position I - Manual operation This setting allows power to the heater uninterrupted by the timer settings. The heat selector switch will control the output (see ‘Using the heater’). Position .......... - ‘Auto’ operation DO NOT disconnect this heater from the mains supply unless it is being taken out of use (e.g. in summer or for storage), otherwise the timer clock will stop. Setting the time of day To set the time of day, rotate the timer dial clockwise (indicated by the arrow) until the correct time of day is opposite the reference mark (see Fig. 4). The 24-hour clock is used ; e.g. time shown for 3 pm is ‘1...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :