Évaluations - 0, GPA: 0
(
)
)
|
Facilité d'utilisation
4. If required, shorten the wall cover to the required dimension (e.g. saw off). Attach the wall cover with the enclosed clips. Screw the wall cover to the wall cupboard. 5. Feed the mains connection cable out of the cupboard. 6. Connect the pipes in the wall cupboard. – If required, attach the air hose to the cupboard ceiling –. 7. Re-insert grease filter (see Operating instructions). Note: The extractor hood housing can be clad inside the wall cupboard (e.g. with chipboard). If so, observe the following: . The intermediate base must not be placed on the extractor hood housing. . Never attach cladding to the housing. . Provide access for customer service. . If the extractor hood is to be installed further back in the cupboard, the stops for the filter drawer can be moved forwards. . To do this, undo the screws, move the stops and retighten the screws. Fitting into wall cupboard .. Check door alignment and readjust if necessary. 1. Remove grease filter (see Operating instructions). 2. Lift the extractor hood into the cupboard from below until both fixing lugs have locked firmly into position. . Align the extractor hood in the cupboard. . Carefully tighten both fastening screws. .. Check that the extractor hood is secure in the cupboard. Exhaust air Circulating air 13,0 13,5 We reserve the right to construction changes within the context of technical development. Weight in kg: 2. Align handle moulding and screw to the appliance. .. Do not pinch the ribbon cable. Moving the operating unit: See Operating instructions. Attaching the handle moulding: A handle moulding must be attached to the filter drawer. This handle moulding may be a wooden strip which matches the kitchen units or a handle moulding available as an optional accessory (see optional accessories on the back page). 1. Using the enclosed template OIII , mark the attachment points on the wooden strip and make holes with a bradawl. When you drill: 2 mm dia – max. 10 mm in depth. Electrical connection WARNING: THIS APPLIANCE MUST BE EARTHED IMPORTANT: Fitting a Different Plug: The wires in the power cord are colourcoded as follows: Removal from the wall cupboard 1. Disconnect from power. 2. Disconnect pipes. Green and Yellow –Earth Blue –Neutral Brown –Live If you fit your own plug, the colours of these wires may not correspond with the identifying marks on the plug terminals. Proceed as follows: 1. Connect the green and yellow (Earth) wire to the terminal in the plug marked ‘E’ or with the symbol ( ), or 3.Removefilters. Undorightandleftfixingscrewsuntiltheextractorhooddropanyfurther. coloured green or green and yellow. 2. Connect the blue (Neutral) wire to the terminal in the plug marked ‘N’ or coloured black. 3. Connect the brown (Live) wire to the terminal marked ‘L’, or coloured red. The extractor hood may be connected to a correctly installed earthed socket only. Attach the earthed socket near the extractor hood in an accessible position. . The earthed socket should be connected via it...
Ce manuel est également adapté pour les modèles :Hoods - D4682X0/02 (12.43 mb)
Hoods - D4682X0/03 (12.43 mb)
Hoods - D4682X0/04 (12.43 mb)
Hoods - D4683X0MC/01 (12.43 mb)