Évaluations - 0, GPA: 0
(
)
)
|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
ENGLISH
Note: Make sure you line up the cut-out areas on the panel with the buttons on
the front of the handle.
Introduction
3 Apply your favorite sticker to the panel as shown on the sticker
Congratulations on your purchase and welcome to Philips!
sheet (Fig. 3).
To fully benefit from the support that Philips offers, register
Reapplying a panel that has been removed
your product at www.philips.com/welcome.
1 Rinse the panel in warm water; you may also use a mild detergent to
General description (Fig. 1)
clean it.
A Hygienic travel cap
2 Let the panel air dry.
B Brush head
C Handle with soft grip
3 Reapply the panel to the white section on the front of the handle.
D Power on/off button with battery charge indicator
Attaching the brush head
E Removable panel with replaceable stickers
F Brushing mode button with mode lights
1 Align the brush head so the bristles point in the same direction as
G Charger
the front of the handle. (Fig. 4)
H Panel
I Sticker
2 Firmly press the brush head onto the metal shaft until it stops.
Note: There is a small gap between the brush head and the handle.
Important
Read this user manual carefully before you use the appliance and save
Charging the Sonicare
it for future reference.
1 Put the mains plug of the charger in the wall socket.
Danger
- Keep the charger away from water. Do not place or store it over or
2 Place the handle on the charger (Fig. 5).
near water contained in a bathtub, washbasin, sink etc. Do not immerse
, The battery charge indicator in the power on/off button flashes to
the charger in water or any other liquid. After cleaning, make sure the
indicate that the toothbrush is charging.
charger is completely dry before you connect it to the mains.
, When the Sonicare is fully charged, the battery charge indicator stops
- This appliance is not a toy. Check brush heads regularly for
flashing and remains on.
cracks. Cracked brush heads may present a choke hazard.
Note: If the battery charge of the Sonicare is low, you hear 3 beeps and the
Warning
battery charge indicator flashes rapidly for 30 seconds after the brushing cycle.
- The mains cord cannot be replaced. If the mains cord is damaged,
Note: To keep the battery fully charged at all times, you may keep the Sonicare on
discard the charger. Always have the charger replaced with one of the
the charger when not in use. When the battery is fully charged, the charger uses a
original type in order to avoid a hazard.
minimal amount of energy. It takes at least 24 hours to fully charge the battery.
- If the appliance is damaged in any way (brush head, toothbrush handle
and/or charger), stop using it.
Using the Sonicare For Kids
- This appliance contains no serviceable parts. If the appliance is damaged,
Brushing instructions
contact the Consumer Care Centre in your country (see chapter
‘Guarantee and service’).
For children under age 8, it is recommended that a parent or adult caregiver
- Do not use the charger outdoors or near heated surfaces.
perform toothbrushing.
- This appliance is not intended for use by persons (including children)
1 Wet the bristles and apply a small amount of toothpaste.
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
2 Place the toothbrush bristles against the teeth at a slight angle
instruction concerning use of the appliance by a person responsible for
towards the gumline (Fig. 6).
their safety.
3 Press the power on/off button to switch on the Sonicare.
- Children should be supervised to ensure that they do not play with the
appliance.
4 Apply light pressure to maximise Sonicare’s effectiveness and let the
Sonicare toothbrush do the brushing for you.
Caution
- If you have had oral or gum surgery in the previous 2 months, consult
5 Gently move the brush head slowly across the teeth in a small back
your dentist before you use the toothbrush.
and forth motion so the longer bristles reach between the teeth.
- Consult your dentist if excessive bleeding occurs after using this
Continue this motion throughout the brushing cycle.
toothbrush or if bleeding continues to occur after 1 week of use.
Note: To make sure you brush evenly throughout the mouth, divide the mouth
- If you have medical concerns, consult your doctor before you use the
into 4 sections using the KidPacer feature (see chapter ‘Features’).
Sonicare.
- The Sonicare toothbrush complies with the safety standards for
6 Begin brushing in section 1 (outside top teeth) until a tune indicates
electromagnetic devices. If you have a pacemaker or other implanted
it is time to move to section 2 (inside top teeth). At the next
device, contact your physician or the device manufacturer of the
tune, move to section 3 (outside bottom teeth). The next tune
implanted device prior to use.
indicates it is time to move to section 4 (inside bottom teeth).
- This appliance has only been designed for cleaning teeth, gums and
The toothbrush automatically switches off at end of the brushing
tongue. Do not use it for any other purpose. Stop using the appliance
cycle (Fig. 7).
and contact your doctor if you experience any discomfort or pain.
7 After you have completed the brushing cycle, you can
- Do not use other brush heads than the ones recommended by the
spend additional time brushing the chewing surfaces of your teeth and
manufacturer.
areas where staining occurs. You may also brush your tongue, with the
- If your toothpaste contains peroxide, baking soda or other bicarbonate
toothbrush switched on or off, as you prefer (Fig. 8).
(common in whitening toothpastes), thoroughly clean the brush head
The Sonicare For Kids is safe to use on:
and the handle with soap and water after each use. Otherwise the
- Braces (brush heads wear out sooner when used on braces)
plastic may crack.
- Dental restorations (fillings, crowns, veneers)
- Do not clean brush heads, handle, charger, charger cover or replaceable
panels in the dishwasher or a microwave.
Brushing modes
Electromagnetic fields (EMF)
The toothbrush automatically starts in the default high mode.
This Philips appliance complies with all applicable standards and regulations
1 Press the brushing mode button to toggle between modes. (Fig. 9)
regarding exposure to electromagnetic fields.
, The green mode light indicates the selected mode.
- High mode: Full-strength mode designed for older/independent
Preparing for use
brushers.
Applying the replaceable panel
- Low mode: Reduced power mode used for training and introducing
younger children to the sonic experience.
The Sonicare For Kids comes with 1 replaceable panel.
1 Remove the adhesive backing from the panel.
2 Apply the panel to the white section on the front of the handle (Fig. 2).
... Ce manuel est également adapté pour les modèles :
Brosses à dents - HX6311/02 (1005.15 kb)