Évaluations - 5, GPA: 4.4 ( )

Fabricant : Empire Comfort Systems Taille : 3.61 mb Nom Fichier : Langue d'enseignement:

VFDM Series Parts View .....................................................................................................31 Service Notes........................................................................................................................32 Page 2 23099-1-0707 IMPORTANT SAFETY INFORMATION • An unvented room heater having an input rating of more than 6,000 Btu per hour shall not be installed in a bathroom • An unvented room heater having an input rating of more than 10,000 Btu per hour shall not be installed in a bedroom or bathroom. • Never burn solid fuels in a fireplace where a gas log set is installed. • Due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies. • Do not place clothing or other flammable material on or near the appliance. • Children and adults should be alerted to the hazards of high surface temperature and should stay away to avoid burns or clothing ignition. • Young children should be carefully supervised when they are in the same room as the appliance. • This unit complies with ANSI Z21.11.2 Unvented Heaters and it also complies with ANSI Z21.60 Decorative Vented Appliances for Solid Fuel Burning Fireplaces. State or local codes may only allow operation of this appliance in a vented configuration. Check your state or local codes. • Correct installation of logs, proper location of the heater and annual cleaning are necessary to avoid potential problems with sooting. Sooting, resulting from improper installation or operation, can settle on surfaces outside the fireplace. • Avoid any drafts that could alter burner flame patterns. Do not allow fans to blow directly into the fireplace. Do not place a blower inside burn box area of firebox. Ceiling fans may create drafts that alter burner flame patterns. Sooting and improper burning will occur as a result of drafts. • WARNING: Do not allow fans to blow directly into the fireplace. Avoid any drafts that alter burner flame patterns. • WARNING: Do not use a blower insert, heat exchanger insert or other accessory not approved for use with this heater. • Periodic examination and cleaning of the venting system of the solid-fuelburningfireplace,includingfrequencyofsuchexamination and cleaning, by a qualified agency. • The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/ NFPA54. • NOTE: Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is imperative that the control compartment, burners and circulating air passageways of the appliance be kept clean. • Any safety screen or guard removed for servicing an appliance must be replaced prior to operating the appliance. Provide adequate combustion and ventilation air. • The flow of combustion and ventilation air MUST NOT be obstructed. • Provide adequate clearances around air openings into the combustion chamber and adequate accessibility clearance for servicing and proper operation. NEVER obstruct the front opening of the appliance. • An unvented room heater intended for installation in a solid-fuel burning fireplace shall comply with the following instructions. • A fireplace screen must be in place when the appliance is operating and, unless other provisions for combustion air are provided, the screen shall have an opening(s) for introduction of combustion air. • Solid-fuels shall not be burned in a masonry orUL127 factory-built fireplace in which an unvented room heater is installed. • Any glass doors shall be fully opened when the appliance is in operation. • Any outside air ducts and/or ash dumps in the fireplace shall be permanently closed at time of appliance installation. • WARNING: Failure to keep the primary air opening(s) of the burner(s) clean may result in sooting and property damage. • WARNING: Before installing in a solid-fuel burning fireplace, the chimney flue and firebox must be cleaned of soot, creosote, ashes and loose paint by a qualified chimney cleaner. WARNING When used without adequate combustion and ventilation air, heater may give off CARBON MONOXIDE, an odorless, poisonous gas. CARBON MONOXIDE POISONING MAY LEAD TO DEATH. Early signs of carbon monoxide poisoning resemble the flu, with Do not install heater until all necessary provisions are made for headache, dizziness and/or nausea. If you have these signs, heater combustion and ventilation air. Consult the written instructions may not be working properly. Get fresh air at once! Have heater provided with the heater for information concerning combustion serviced. and ventilation air. In the absence of instructions, refer to the Some people – pregnant women, persons with heart or lung disease, National Fuel Gas Code, ANSI Z223.1, Section 5.3 or applicable anemia, th...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :