Évaluations - 4, GPA: 3.5 ( )

Fabricant : Monessen Hearth Taille : 2.39 mb Nom Fichier : Lennox_Hearth_MPB_Installation_850033M.pdf Langue d'enseignement:

Logs should be placed in the order shown. Position the center log on the burner first, then place the glowing embers as shown in Figure 52. Place the rear log, both the right and left, and then the smaller left and right top logs. All logs that have notches to fit over the grate tines should be positioned with these notches directly against the grate. All top logs that rest on lower logs, do so over flattened mounting faces in the bottom logs. Proper log and twig placement is critical to encourage outstanding fl ame appearance and prevent sooting. Figure 28: Log Set 24M25 Placement NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. LENNOX HEARTH PRODUCTS • MERIT PLUS® B-VENT GAS FIREPLACES (MPB33/35/40/45) • INSTALLATION INSTRUCTIONS STEP 10. REMOVING AND INSTALLING THE GLASS DOOR WARNING • Do not attempt to substitute the materials used on the door, or replace cracked or broken glass. • Handle this glass with extreme care! Glass is susceptible to damage – Do not scratch or handle roughly while reinstalling the glass door frame. • The glass door of this appliance must only be replaced as a complete unit as provided by the manufacturer. Do not attempt to replace broken, cracked or chipped glass separately. • Do not attempt to touch the front enclosure glass with your hands while the fi replace is in use. WARNING Do not operate appliance with the glass front removed, cracked or broken. AVERTISSEMENT Ne pas utiliser l'appareil si le panneau frontal en verre n'est pas en place, est craque ou brise. Only doors certifi ed with the appliance shall be used. Seules des portes certifi ees pour cet appareil doivent etre utilisees. WARNING: DO NOT abuse glass door by striking or slamming shut. Removing the Glass Enclosure Panel (see Figure 29) Remove the top louver assembly. Open the lower control compartment door (see Figure 29 ) by pressing in simultaneously at the left and right top corners of the door (the door is hinged at the bottom). Remove the bottom compartment door by sliding the hinge pin, located at the door’s left side, to the right until it disengages from the left corner post hole. Pull the door diagonally to the left, away from the fi replace. Locate the latch at the top of the control compartment and disengage it from the door frame bottom vee-fl ange, pulling down on the handle to open it. Installing the Glass Enclosure Panel (see Figure 29) Retrieve the glass door. Visually inspect the gasket on the backside of the frame. Gasket surface must be clean, free of irregularities and seated fi rmly. Position the door in front of the fi rebox opening with the bottom of the door held away from the fi replace (see Figure 29). Hook the top fl ange of the door frame over the top of the fi rebox frame. Let the bottom of the door frame swing gently in towards the fi replace ensuring that the gasket seats evenly as the door frame draws shut. Fasten the latch located underneath the fi rebox fl oor to the door's vee-fl ange. Close the latch securely. Top Fl...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :