Évaluations - 3, GPA: 4.3 ( )

Fabricant : Fellowes Taille : 75.77 kb Nom Fichier : cut4810.pdf Langue d'enseignement:

We recommend the purchase of a spare knife, so that a sharp knife is always available. This ensures that your machines remains operative even if the original knife has to be sent away for re- sharpening. Look for a professional re-sharpening service locally. Of course, your distributor knows one and can help you in this regard. The knife change must be executed by one person only. The cutting edge of the knife is extremely sharp. In order to avoid injuries, the knife has to be handled with the utmost care. Transportation of knife is only permitted in specially designed wooden cases, which are supplied with every spare knife ordered from your local distributor. The following description applies to model IDEAL 4810-11. Please note, that with models IDEAL 4810 and IDEAL 5210 the re-set button (#12) must be pushed prior to activating the knife with the two push buttons (#5). 1. Turn the cutting depth adjustment screw (#4) all the way to the left (-) and then a complete turn to the right (+). 2. Bring the knife down by pressing both push button switches (#5). Release one of the switches and turn main switch (#11) to position “0” (off). The knife stays in its lowest position on the cutting stick (#2). 3. Remove knife screw (E). See illustration I. 4. Remove the securing screw (F) on the knife adjustment flap (#20). Lift up the flap (#20) and turn out the three knife adjustment screws (X, Y, and Z) by approximately 5 mm (1 /4”). See illustration II. 5. Turn main switch (#11) to position “|” (on). The knife carrier (#17) goes back to its home position. Turn main switch back to “off” position. 6. Remove knife screws (B and D) and replace them with the two knife holders from the tool box. Tighten securely. 7. Take out knife screws (A and C), loosen knife holders and lower the knife downwards from the knife carrier (#17). Then, due to the length of the knife, a sideways movement between the knife guide plates is required for removal. 8. Take out cutting stick (#2), turn, rotate or exchange it and place it back into machine. IMPORTANT – Hook cutting stick into pin, which is located on left between the knife guide plates. 9. Insert knife holders into second and fourth threaded hole (B and D) of the new knife. Ensure that the ends of the knife holders are protruding from the other side of the knife. Place knife (#18) into knife carrier (#17) and secure with knife holders. 10. Screw in knife screws (A and C) – snuggly, don’t tighten. 11. Remove knife holders. Screw in knife screws (B and D) – snuggly, don’t tighten. 12. Spread one to three sheets of paper across the entire cutting length. Bring the knife (#17) down. Release only one push button (#5) and turn main switch (#11) to position “0” (off) again to stop the knife in its lowest position. 13. Screw in knife screw (E) – snuggly, don’t tighten. 14. The parallel adjustment of the knife is done via the knife adjustment screws. Push knife down by screwing in the knife adjustment screws (X, Y, and Z) evenly, un...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :