Évaluations - 4, GPA: 4 ( )

Fabricant : Fellowes Taille : 75.77 kb Nom Fichier : Langue d'enseignement:

IMPORTANT – Hook cutting stick into pin, which is located on left between the knife guide plates. 9. Insert knife holders into second and fourth threaded hole (B and D) of the new knife. Ensure that the ends of the knife holders are protruding from the other side of the knife. Place knife (#18) into knife carrier (#17) and secure with knife holders. 10. Screw in knife screws (A and C) – snuggly, don’t tighten. 11. Remove knife holders. Screw in knife screws (B and D) – snuggly, don’t tighten. 12. Spread one to three sheets of paper across the entire cutting length. Bring the knife (#17) down. Release only one push button (#5) and turn main switch (#11) to position “0” (off) again to stop the knife in its lowest position. 13. Screw in knife screw (E) – snuggly, don’t tighten. 14. The parallel adjustment of the knife is done via the knife adjustment screws. Push knife down by screwing in the knife adjustment screws (X, Y, and Z) evenly, until the paper is cut across its whole length. 15. Should the scope of the adjustment available by means of the knife adjustment screws be insufficient, resort to the knife depth adjustment screw (#4). Turn it in steps of half a turn clockwise (+). After each step a test cut has to be executed. If the paper is cut through only on one side, proceed with parallel adjustment of knife as described under (#12 and #14). IMPORTANT – Both the above methods (#14 and #15) of knife adjustment offer an adjustment range of approximately 5 mm (1 / 4”). 16. Tighten knife screws (B, C, D and E) firmly while the knife is lowered on the cutting stick. 17. Turn main switch (#11) to position “|” (on). The knife returns to its home position. 18. Tighten knife screw (A) firmly. Screw in securing screw for knife adjustment flap (#20). 19. Make a test cut with a paper pile using the full cutting height. If necessary do a final adjustment with the cutting depth adjustment screw (#4). 20. IMPORTANT – The clamp bar must be adjusted in a way that the cutting edge of the knife in its home position is covered by the clamp bar. Changing of cutting stick Should the bottom sheet of a paper pile not be cut across its full length, the cutting stick (#2) must be turned, rotated or exchanged. IMPORTANT – If the knife has been lowered by means of the cutting depth adjustment screw (#6) to compensate for a worn cutting stick, then this adjustment screw (#6) has to be turned back to its highest setting before the cutting stick (#5) is turned, rotated or exchanged. Then re-adjust screw (#6) again to obtain the optimal cutting depth. A knife that is set too low can inflict damage not only to the cutting stick, but also to the knife and the knife drive system. The cutting stick (#2) is inserted into the machine table and fixed by hooking it into a pin located on the left between the knife guide plates. Lubrication IMPORTANT – Before removing any machine covers for service or maintenance, always disconnect machine from power supply. From time to time all mov...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :