Évaluations - 3, GPA: 4
(
)
)
|
Facilité d'utilisation
Any floor unevenness should be corrected with leveling legs located on the bottom of the dryer. Tools and materials required • Phillips head and flathead screwdrivers • Channel-lock adjustable pilers • 1/2 inch open end wrench • Carpenter’s level • Measuring tape (12ft. min.) • Duct tap • Rigid or flexible metal 4 inch (102cm) duct • Vent hood Electrical requirements U.S. Only Power supply: 3 or 4 wire, 240 Volt, 30 Amp,60Hz, 1 Phase Power Supply Cord Kit (not supplied when sold in the United States) – Purchase to meet local electrical codes. The dryer MUST employ a 3-conductor power supply cord NEMA 10-30 Type SPDT RATED AT 240 Volt AC minimum, 30 Amp., with 3 open end spade lug connectors with upturned ends or closed loop connectors and marked for use with clothes dryers. If being installed in a manufactured (mobile) home,the dryer MUST employ a 4-conductor power supply cord. NEMA 14-30 type SRDT or ST (as required) rated at 240 Volt AC Minimum, 30 Amp., with 4 open end spade lug connectors with upturned ends or closed loop connectors and marked for use with clothes dryers. See Electrical Connections for A 4-Wire System. Canada Only Candian models are supplied with the appropriate power cord. Unpacking Your Dryer 1. Remove all packaging material. This includes the foam base and all adhesive tape holding the dryer accessories inside and outside. 2. Inspect and remove any remains of packaging, tape or printed materials before using the dryer. English Exhaust System Connections Requirements and Instructions WARNING The following are specific requirements for proper and safe operation of your dryer. Failure to follow these instructions can create excessive drying times and fire hazards. 1. Do not use plastic flexible duct to exhaust the dryer. Excessive lint can build up inside exhaust system and create a fire hazard and restrict air flow. Restricted air flow will increase dryer times. If your present system is made up of plastic duct or metal foil duct, replace it with a rigid or flexible metal duct. Ensure present duct is free of any lint prior to installing dryer duct. 2. If the dryer is on exhausted out doors, some fine lint will be expelled into the laundry area. An accumulation of lint in any area of the home can create a health and fire hazard. To reduce risk of fire, dryer MUST BE EXHAUSTED OUTDOORS. 3. Do not allow combustible material (for example: clothing, draperies/curtains, paper) to come in contact with exhaust system. The dryer must not be exhausted into a chimney,a wall,a ceiling,or any concealed space of a building which can accumulate lint, resulting in a fire hazard. 4. Exceeding the length of duct pipe or number of elbows allowed in the ”Maximum Length” charts can cause an accumulation of lint in the exhaust system, Plugging the system could create a fire hazard, as well as increase drying times. 5. Do not screen the exhaust ends of the vent system, nor use any screws of rivets to assemble the exhaust system. Lint can become ca...
Ce manuel est également adapté pour les modèles :Séchoirs - CGDE700AW (285.6 kb)
Séchoirs - CGDE700AW (285.6 kb)
Séchoirs - CGDE700AW (285.6 kb)
Séchoirs - CGDE700AW (285.6 kb)