|
Par ce dispositif a également d'autres instructions :
Facilité d'utilisation
Congratulations on your purchase of the HP StorageWorks 8/20q
HP StorageWorks
Fibre Channel Switch Rack Mount Kit. This document provides
procedures for installing the 8/20q Fibre Channel Switch in an HP
supported rack.
8/20q Fibre Channel Switch
Rack Mount Kit quick start
Supported HP custom racks
installation instructions
The rack mount kit is supported with the following HP custom racks
only:
• HP 9000 Series Rack
• HP 10000 Series Rack
• HP 10000 G2 Series Rack
Related documentation
For the latest documentation for the 8/20q Fibre Channel Switch,
see the HP website http://www.hp.com/go/8Gb-SCC.
Before you begin
WARNING! To reduce the risk of personal injury or damage to
the equipment, ensure that:
• In single-rack installations, stabilizing feet are attached to the
rack.
• In multiple-rack installations, racks are coupled together.
• Leveling jacks on the rack are extended to the floor.
• The full weight of the rack rests on the leveling jacks.
• Heavy items, such as uninterruptible power supplies and hard
drive storage enclosures, are instal ed near the bot om of the
rack.
• Similar components are installed next to each other in the rack.
Because devices are of differing depths, this will facilitate
Printed on at least 50% total recycled fiber with at least 10%
maintenance and service tasks.
post-consumer paper
• Only one device in a rack is extended at a time. A rack may
become unstable if more than one device is extended.
© Copyright 2008 Hewlet -Packard Development Company, L.P.
First edition: February 2008
Product names mentioned herein may be trademarks of their
CAUTION:
respective companies as reflected by an associated footnote.
• For proper airflow, the SFP+ media side (port side) of the device
The information in this document is subject to change without notice.
must face the front of the rack. Mounting the switch in this
Printed in the U.S.
direction allows air to enter from the front of the rack (SFP-port
www.hp.com
side of switch) and exhaust through the back of the rack
(power-supply side of switch). This prevents overheating, which
may cause equipment in the rack to fail.
• Allow a minimum of 63.5 cm (25 in) clearance in front of the
rack to allow the doors to open fully, and 76.2 cm (30 in) in
back of the rack to allow for servicing and airflow.
• If the device is mounted in a closed rack or there are multiple
rack-mounted devices, make sure that the operating temperature
inside the rack enclosure does not exceed the maximum rated
ambient temperature.
• Multiple rack-mounted devices connected to the same AC supply
circuit may overload that circuit or the AC supply wiring.
Consider the power source capacity and the total power usage
of all switches on the circuit.
• Reliable grounding in the rack must be maintained.
*AK242-96002*
Page 1
... Ce manuel est également adapté pour les modèles :
données dispositifs de traitement - HP 8/20q Fibre Channel Switch/S-Buy (378.34 kb)
données dispositifs de traitement - HP 8/20q Fibre Channel Switch (378.34 kb)
données dispositifs de traitement - HP 8Gb Simple SAN Connection Kit (378.34 kb)
données dispositifs de traitement - HP 8Gb Simple SAN Connection Kit/S-Buy (378.34 kb)