Évaluations - 2, GPA: 4.5
(
)
)
|
Facilité d'utilisation
Failure to observe these instructions may put the mechanical parts out of phase. When the on/off switch is in position 0, the supply terminals remain live. INTENDED USE The IPSO range of roller ironers has been designed for ironing flat linen. Any other use is to be considered incorrect and therefore unreasonable. The manufacturer cannot be held liable for any damage to things or injury to persons caused by improper, incorrect or unreasonable use. THE MANUFACTURER CANNOT BE HELD LIABLE SHOULD THE IRONER BE TAMPERED WITH OR MODIFIED BY UNAUTHORISED PERSONS. OPERATION 1. Switch on the main switch (B) situated on the slide for linen, turning it to position 1. 2. Push the switch START (I) to activate the control circuit. 3. Adjust the temperature using the rotor on control panel. The yellow warning light will remain on for a few minutes until the set temperature is reached. 4. With the help of the feed-in wooden table, place the item to be ironed on the roller. 5. Press the foot pedal control, to be found along the whole length of the machine, in order to activate the roller rotation and start work. 6. At the end of the ironing session, push the red switch STOP (0). The ironer remains idle. Subsequently put the main switch to position 0. WARNINGS AND ADVICE Prior to carrying out any inspection or work on the ironer, make sure that it is disconnected from the mains power supply. The fundamental part to operation of all the models is a heating element (ironing plate). Avoid deliberate contact with points which in normal working position (hands resting on the table) cannot be reached. The noise level produced by our range of ironers is less than 70 dB. When the ironer is used for the first time the insulation on the heating elements emits a peculiar smell for a few minutes. This is normal and should not alarm the user. It is advisable to begin by ironing lightweight items which require a lower temperature and go on to heavier items, gradually raising the temperature by means of the thermostat control. When the ironer is in operation the roller covering absorbs a certain amount of humidity. For this reason at the end of the ironing session it is advisable to let the roller turn for a couple of minutes. This will help to evaporate residual humidity and keep longer the roller covering in good condition. When the machine is turned off, make sure that the roller and the ironing plate are not in contact. Temperatures above 140/150°C will increase production but will also scorch the items or the roller covering. During the washing cycle prior to ironing, the use of suitably softened water is recommended in order to prevent scale building up on the ironing surface, which would dirty the linen. A suitable amount of washing powder is also recommended in order to avoid deposits which cause friction between the product and the ironing surfaces. In the event of a power failure, avoid accidental scorching by raising the ironing plate. This can be done manually. Turn off the main switch and open the door on the right side using the relative key. The handwheel is situated under the ironing plate motor, to be found behind the right-hand panel of the ironer, should be turned counterclockwise (see fig. 3) to move the ironing plate away from the roller. Take the time to check the exact position of th...
Ce manuel est également adapté pour les modèles :Fers - RI1200/25 (669.04 kb)
Fers - RI1400/25 (669.04 kb)