Évaluations - 2, GPA: 4.5
(
)
)
|
Facilité d'utilisation
ORIGINAL SPARE PARTS The original spare parts are specially made to fulfil our requirements regarding their manufacture, correspondence to the original components and materials used and are therefore ideal for our ironers. To order spare parts, provide the following details: 1) the name of the machine - see data on the rathing plate 2) the serial number - see data on the rathing plate 3) the code of spare part - see spare parts list 4) the quantity required. REPLACING THE ROLLER COVERING 1. Remove the cover sheet and flannel. Wind off the steelwool, completely exposing the roller. 2. Take a new roll of steelwool, cut one and off diagonally and place on the left-hand side of the roller with a slope of approx. 30 degrees. Keep tight. 3. Begin winding towards the right-hand end with the ironing plate under pressure, taking care not to overlap the edges; then take a second layer from right to left in the same way. Repeat this operation until the circumference of the roller reaches 770 mm. 4. Spread the flannel evenly over the padded roller and tighten with the ironing plate under pressure until it is fully wound. Raise the temperature to approx. 130°C and let the roller rotate for a few minutes until the flannel cover is settled. 5. Place the narrowest end of the cover sheet approx. 10 cm under the edge of the flannel, making sure it is perfectly smooth and parallel. Put the ironing plate under pressure and wind the sheet round. Let the roller rotate for a few minutes. When the cover sheet is settled, secure the ends. Every maintenance operation must be carried out by professionally qualified personnel. TROUBLESHOOTING TROUBLE POSSIBLE CAUSE REMEDY Upon switching on the ironer does not work. Mains power failure. Magnetothermal switc h intervention. Card protection fuse (F4) blown. Check if supply terminals are live. Check dispersion toward earth. Replace fuse and check for cause. The roller does not turn and the ironing plate does not drop. Motor fuse (F3) blown. Motor thermal feeler activated. Emergency devices activated (display shows “Err”.) Replace fuse and check for cause. Wait some minutes for the reestablishment of feeler contact. Disactivate the emergency device and press the pedal. After adjusting the temperature by means of the thermostat, the ironing plate does not heat. Safety thermostat activated. Thermostat probe disconnected: display shows “Er1” for the right, “Er3” for the left. Thermostat probe in short circuit: display shows “Er2” for the right, “Er4” for the left. Measured temperature difference between right and left probes higher than 40°C. Reset the safety thermostat using the relative push button. Check probes connection. Use properly the whole ironing surface. N.B.: All checks and any technical work must be carried out by fully competent, qualified personnel. FR TRANSPORT - HANDLING - DEBALLAGE Le transport de la calandre doit etre effectue comme illustre sur les dessins a l’exterieur de l’emballage. Les elements de l’emballage (sachets en plastique, polystyrene expanse, clous, vis, bandes metalliques ou en plastique, etc.) ne doivent pas etre laisses a la portee des enfants ou abandonnes dans l’environnement, pouvant representer une source de danger et de pollution. Ces materiaux doivent etre jetes dans les endroits prevus a cet effet. INSTALLATION Deba...
Ce manuel est également adapté pour les modèles :Fers - RI1200/25 (669.04 kb)
Fers - RI1000/25 (669.04 kb)