Évaluations - 4, GPA: 4 ( )

Fabricant : Bosch Taille : 613.74 kb Nom Fichier : 4bc890a8-5f65-8034-1df6-e5ec6e218fb8.pdf Langue d'enseignement:

• You will need an original AEG charcoal filter for the recirculation function. (Available from your local Service Force Centre). Fig. 1 A = ON/OFF switches (Motor, light) B = Grease filter C = Light D = Control panel E = Visor (Removable) Control Panel • The switches are mounted on the upper right side of the visor (Fig. 1 -E). The numbers and symbols have the following meanings (from left to right): DF 6260 - CHDF 6260 DF 6160 -DF 6260-ml/1 1 = fan set 1 = Continuously variable fan control 2 = fan set 2 3 = fan set 3 = Intensive setting 4 = fan set 4 = Light = Light = Light OFF = Light OFF = Light ON = Light ON The fan is controlled by moving the sliding switch. The extractor part (visor) of the hood is used to switch the fan on and off when the appliance is switched on (Motor). When the visor of the appliance is withdrawn, the fan automatically switches on. If the visor is pushed in without operating the switches, the fan is switched off. The lighting can be separately switched on and off with the slide switch. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared. Maintenance and care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. • Never insert pointed objects in the motor’s protective grid. • Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. • Only ever clean the switch panel and filter grille using a damp cloth and delicate detergents. • It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. Metal grease filter • The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the extraction or internal recirculation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Open the metal grease filter • Pull out the visor, remove the rear grease filter pulling the handle designed for this purpose, then proceed in the same way to remove the front grease filter. Fig. 2. Hand washing • Soak grease filters for about one hour in hot water with a grease- loosening cleaner, then rinse off thoroughly with hot water. Repeat the process if necessary. Refit the grease filters when they are dry. Dishwasher • Place grease filters in dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Repeat the process. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. • Clean the inner housing using a hot detergent solution only (never use caus...

Téléchargez votre

Pour télécharger, entrez 2 chiffres :