Failure to observe these instructions may put the mechanical parts out of phase. When the on/off switch is in position 0, the supply terminals remain live. INTENDED USE The IPSO range of roller ironers has been designed for ironing flat linen. Any other use is to be considered incorrect and therefore unreasonable. The manufacturer cannot be held liable for any damage to things or injury to persons caused by improper, incorrect or unreasonable use. THE MANUFACTURER CANNOT BE HELD LIABLE SHOULD TH

The roller surface must be correctly utilised (see fig. 3) in order to keep the surface even over the whole circumference of the roller and to obtain optimum temperature distribution. In this way scorching of the ironed product and a drop in hourly machine production are both avoided. SAFETY DEVICES FINGER GUARD -The finger guard (A) prevents the operator's hands being exposed to the heated ironing plate. By exerting minimum pressure on the bar, the ironing plate is raised from the roller. To be

ORIGINAL SPARE PARTS The original spare parts are specially made to fulfil our requirements regarding their manufacture, correspondence to the original components and materials used and are therefore ideal for our ironers. To order spare parts, provide the following details: 1) the name of the machine - see data on the rathing plate 2) the serial number - see data on the rathing plate 3) the code of spare part - see spare parts list 4) the quantity required. REPLACING THE ROLLER COVERING 1. Remo

The ironer remains idle. Subsequently put the main switch to position 0. WARNINGS AND ADVICE Prior to carrying out any inspection or work on the ironer, make sure that it is disconnected from the mains power supply. The fundamental part to operation of all the models is a heating element (ironing plate). Avoid deliberate contact with points which in normal working position (hands resting on the table) cannot be reached. The noise level produced by our range of ironers is less than 70 dB. When th

Repeat this operation until the circumference of the roller reaches 770 mm. 4. Spread the flannel evenly over the padded roller and tighten with the ironing plate under pressure until it is fully wound. Raise the temperature to approx. 130°C and let the roller rotate for a few minutes until the flannel cover is settled. 5. Place the narrowest end of the cover sheet approx. 10 cm under the edge of the flannel, making sure it is perfectly smooth and parallel. Put the ironing plate under pressure a

FIREPROOF ROLLER COVERING -All models are provided with roller covering in fireproof material. INSULATION OF INDUCTION HEATED PARTS -The cover rear serves to insulate the external ambient from the high temperatures reached by the ironing plate and is lined with a layer of high quality insulating material. PEDAL -The foot pedal control (C) also has a rapid stop function: upon pressing it during working, it moves the heating part away from the roller. Before starting working, control the functioni