7 Stride length measurement .......................................... 8 Operating Instructions Activating the Battery...........................................................9 Setting the Time....................................................................9 Setting the Weight ..............................................................10 Setting the Stride Length....................................................10 Attaching the Pedometer ...............................................

The battery may explode. A Dispose of the device, battery, and components according to applicable local regulations. Unlawful disposal may cause environmental pollution. CARE AND MAINTENANCE A Do not disassemble or modify the unit. Changes or modifications not approved by Omron Healthcare will void the user warranty. A Do not subject the unit to strong shocks, such as dropping the unit on the floor. yfy Do not submerge the unit or any of the components in water. /К Do not press the button

1/2 inch (1 - 2 cm) Air Tube Blue Strip 7. Wrap the cuff firmly in place around your arm using the cloth strip. 21 APPLYING THE ARM CUFF APPLYING THE CUFF ON THE RIGHT ARM Apply the cuff to your right upper arm so the thumb grip is centered on the inside of your inner arm. The bottom of the cuff should be approximately 1/2'' above your elbow. Thumb Grip NOTE: Be careful not to rest your arm on the air tube. This will restrict the flow of air to the cuff. 22 TAKING A MEASUREMENT The monitor autom

14 3. Remove the old battery. Take the battery out with easily breakable. NOTE: • DO NOT use a pair of metal tweezers or a screwdriver. CAUTION Dispose of the device, battery, and components according to applicable local regulations. Unlawful disposal environmental pollution. CAUTION Do not throw the battery into fire. The battery may explode. 4. Insert the new battery. Place the positive (+) side of the battery upward. Insert the battery in the direction of the arrow as illustrated. 5. Replace

omRon INSTRUCTION MANUAL MÊkJntelli ® sense Automatic Blood Pressure Monitor with Arm Cuff Model HEM-711AC ENGLISH I ESPAÑOL CONTENTS Before Using the Monitor Introduction ..........................................2 Important Safety Notes..................................3 Before Taking a Measurement............................4 Operating Instructions Know Your Unit.......................................5 Unit Display .........................................6 Irregular Heartbeat

Orange Use the Standard Cuff Use the Large Cuff Purple APPLYING THE CUFF ON THE LEFT ARM 1. Make sure the air plug is securely inserted in the main unit. 25 APPLYING THE ARM CUFF 2. Remove tight-fitting clothing from your upper left arm. 3. Apply the cuff to your left upper arm so the blue arrow is centered on the inside of your arm and aligned with your middle finger. The air tube runs down the inside of your arm. The bottom of the cuff should be approximately 1/2" above your elbow. 1/2 inch (1

You may find it useful also to refer to the printed instructions that came with your device. Troubleshooting Tips Problem Possible Causes Solutions Blood Pressure Monitor status in Connection Center shown as 'Your device isn't connected' Connection is not well established Ensure the USB cable is properly plugged into the computer and the device. Disconnect the USB cable and the reconnect it, then wait several seconds There are measurements on your blood pressure device but they are not up

10 11 CHING PEDOMETER 1. Incorrect unit position • When the front of the main unit (shown to the right) or horizontal The unit may not count steps correctly in the following conditions: ATTACHING PEDOMETER Attach the unit belt or the your waistband. • Do not place the unit in NOTE: Press the clip open to remove the The clip may cause scratches to the belt if it is attached depending on the belt material. The unit may not count steps correctly in the following conditions: ATTACHING PEDOMETER Atta

. . . . . . . . . . . . . . . . . . . . . . .3 Your blood pressure monitor: the benefits . . . . . . . . . .4 Battery installation / replacement . . . . . . . . . . . . . . . .5 How to set time and date . . . . . . . . . . . . . . . . . . . . . .6 How to apply the cuff . . . . . . . . . . . . . . . . . . . . . . . . .7 How to take a reading . . . . . . . . . . . . . . . . . . . . . . . . .9 How to use the memory function . . . . . . . . . . . . . . . .11 How to use the computer interface . . . .

Normal USB Connector 3. Plug the mini USB connector (Small Connector) into the USB connector. “PC” will appear on the display when the USB cable is connected correctly. Mini USB Connector 33 3333 TRANSFERRING DATA TO A PERSONAL COMPUTER TRANSFERRING DATA TO A PERSONAL COMPUTER 4. Click [Download Data] icon to import the data. 5. The Confirm dialog appears. Click [Yes] to import the data. 6. Start importing data. Click [Cancel] if you want to cancel. 7. The dialog appears when complete. Click [OK