Log: Owner's Manual Model Digital Multitracker rostex «3 II il S 5 Table of Contents Introduction.........................................................6 Precautions...........................................................6 Notes about power supply.....................................................-..............6 Notes on handling the hard disk........................-..................................7 Notes on the setup location..................................................
You can select “On” or “Off” of the error tone for “Write error”, “Input clip” and “BATT warning”, as well as can set the time for “Disk warning”. 1) While the unit is stopped, press the [SHIFT] key to light the SHIFT indicator, followed by the [ENTER/YES] key. 2) While “SYS SETUP” is highlighted, press the [ENTER/YES] key. The display now shows the SYS SETUP menu screen. 1. A write error happens during recording. [Write error] 2. The peak indicator lights due to input overload during analog rec
Adjust the [TRIM] control appropriately so that the [PEAK] indicator is lit at the loudest part of playing.
However, there is also a way to record all tracks with one input jack. You can do this by exchanging a recorded track that was recorded normally with an unrecorded track. This procedure is called “Track Exchange”. This feature is convenient to use when recording with all G and H [INPUT] jacks that can be connected with a condenser mic or balanced output, for example. Note that the VF160EX comes with 16 tracks, plus 8 additional tracks. The Track Exchange feature makes it possible to exchange the
When you raise the GROUP MASTER control (which corresponds to the channel INPUT fader or the track for ping-pong recording) higher than the standard level (usually "8" on the fader scale or higher; however, it depends on the equalizer setting), oscillation will occur. (The level meter will peak for the oscillating channel signal.) If you do not correct this situation and you continue to monitor the signal through the headphones or monitor speakers, unexpected oscillation noise will be output, c
2. Mix the signals recorded on tracks 1 through 6 and record the mixed signal onto tracks 7 and 8. Then tracks 1 through 6 can be used to record other materials. This is the basic technique used for Multitrackers. We recommend that tracks 7 and 8 are basically used as the destination tracks of “track bounce” from tracks 1 through 6. See “Advanced Operation” for details about the track bounce technique. In addition, tracks 7 and 8 play an important role in “training mode” and “mastering mode” des
DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Tne iighinng flash with arrownead symbol, within an equilateral triangle, is intended to alori the user to the presence of uninsulated "dangerous voltage" within me product's enclosure lhat may be of sufficient magnitude to constitute a risk ot electric shock to persons The exclamation pont withm an eauiiatera: triangle is intended to alert the user to the oresonce ot important op
• File name of the audio file • Descriptor information (BWF Sound Sequence information) • File creation date (year/month/day) and time (hour/minute/second) • Start time information (LTC start time) • End time information (LTC time at the recording end) • Duration information (of audio area, shown in time code) • File volume (occupying space) Checking file information 1. Select the “File Info. ” menu and press the [ENTER] key. The display changes to show the dedicated “File info.” screen, on whic
Applications 10 SECTION 9 Maintenance 11 SECTION 10 Accessories 11 SECTION 11 Block Diagram 12 SECTION 12 Specifications 13 SECTION 13 Bibliography 14 Safety Instructions 15 WARNING: To avoid possible electric shock hazard, do not expose this appliance to rain or moisture. There are no user-serviceable parts inside. Refer servicing to qualified service personnel. Figure, 2-1 CONTROL LAYOUT REAR PANEL 1 section 1 FEATURE DESCRIPTIONS 1. INPUT SELECTOR. A three position switch to se
